1、INCH-POUND MIL-DTL-11484/93D 30 September 2008 SUPERSEDING MIL-DTL-11484/93C 27 September 1996 DETAIL SPECIFICATION SHEET LAPEL BUTTON, AWARD FOR EXCELLENCE, DEFENSE INTELLIGENCE AGENCY This specification is approved for use by all Departments and Agencies of the Department of Defense. The requireme
2、nts for acquiring the product described herein shall consist of this specification sheet and the latest issue of MIL-DTL-11484. MATERIAL: Red Brass FINISH: Gold Plated, Gold Plated, Matte Finish, Polished Highlights and shall match The Institute of Heraldry (TIOH) Metal Finish Chip Number 8. DIMENSI
3、ONS: HEIGHT (overall): 9/16 inch (REF) WIDTH (overall): 1/2 inch (REF) THICKNESS (at edge): 0.050 inch + 0.005 inch AMSC N/A Page 1 of 2 FSC 8455 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-11484/93D Page 2 of 2 NOTES: 1. The term (REF) r
4、efers to the measurements taken from the Government furnished hub or die. 2. Lapel button shall be lacquered. 3. Attaching device shall be prong with pick and wing type clutch. The prong shall be centered on the reverse side and fused or soldered to the lapel button. CHANGES FROM PREVIOUS ISSUE: The
5、 margins of this specification are marked with vertical lines to indicate where changes from the previous issue were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate
6、 the requirements of this document based on the entire content irrespective of the marginal notations and relationship to the last previous issue. Custodian: Preparing activity: Army - IH Army - IH DIA DI (Project No. 8455-2008-201) Review activities: DLA - CT Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
