ASTM E1358-1997(2013) Standard Test Method for Determination of Moisture Content of Particulate Wood Fuels Using a Microwave Oven《使用微波炉测定粒状木质燃料水分含量的标准试验方法》.pdf

上传人:visitstep340 文档编号:528534 上传时间:2018-12-05 格式:PDF 页数:2 大小:56.08KB
下载 相关 举报
ASTM E1358-1997(2013) Standard Test Method for Determination of Moisture Content of Particulate Wood Fuels Using a Microwave Oven《使用微波炉测定粒状木质燃料水分含量的标准试验方法》.pdf_第1页
第1页 / 共2页
ASTM E1358-1997(2013) Standard Test Method for Determination of Moisture Content of Particulate Wood Fuels Using a Microwave Oven《使用微波炉测定粒状木质燃料水分含量的标准试验方法》.pdf_第2页
第2页 / 共2页
亲,该文档总共2页,全部预览完了,如果喜欢就下载吧!
资源描述

1、Designation: E1358 97 (Reapproved 2013)Standard Test Method forDetermination of Moisture Content of Particulate WoodFuels Using a Microwave Oven1This standard is issued under the fixed designation E1358; the number immediately following the designation indicates the year oforiginal adoption or, in t

2、he case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. Asuperscript epsilon () indicates an editorial change since the last revision or reapproval.1. Scope1.1 This test method provides an alternative method toMethod E871, for the determination

3、of the moisture of particu-late wood fuels. Particulate wood fuels are defined in E1126.1.2 The values stated in SI units are to be regarded asstandard. No other units of measurement are included in thisstandard.1.3 This standard does not purport to address all of thesafety concerns, if any, associa

4、ted with its use. It is theresponsibility of the user of this standard to establish appro-priate safety and health practices and determine the applica-bility of regulatory limitations prior to use.2. Referenced Documents2.1 ASTM Standards:2E871 Test Method for Moisture Analysis of ParticulateWood Fu

5、elsE1126 Terminology Relating to Biomass Fuels (Withdrawn2003)33. Summary of Test Method3.1 Moisture is determined by establishing the loss in massof the sample when heated under rigidly controlled conditionsof temperature, time, sample mass, and equipment specifica-tions.44. Significance and Use4.1

6、 This test method provides a rapid determination formoisture in particulate wood fuels in several minutes. Thestandard method, E871, requires a minimum of 18 h. Thismethod is applicable to situations such as the spot-check of themoisture delivered by truck where a quick indication of themoisture of

7、wood delivered is desirable.5. Apparatus5.1 Microwave OvenAny standard commercial micro-wave oven having a power output of at least 600 W can beused.6. Procedure6.1 Obtain a 50 g sample of the wood to be tested usingtechniques outlined in Method E871.6.2 Determine the weight of 3 sheets of standard

8、papertowels placed on top of each other. Record this mass as MT(Mass of Towels).6.3 Place the 50 g sample of the wood on top of the papertowels and determine the mass of the initial sample. Record themass as MSTI(Mass of Sample and Towels Initial).6.4 Place the sample in the microwave and heat on fu

9、llpower using the schedule shown in Table 1 for the type ofwood fuel being tested. Remove sample and towels from ovenafter each heating interval, weigh, and stir. When the masschange between successive weighings is less than 0.5 g, recordthis mass as MSTF(Mass of Sample and Towels Final).7. Calculat

10、ion7.1 Calculate the mass percent moisture in the sample asfollows:Moisture in Sample, %5 MSTI2 MT! 2 MSTF2 MT!/MSTI2 MT!8. Precision and Bias8.1 The following criteria should be used for judging theacceptability of the results:8.1.1 RepeatabilityDuplicate results by the same labora-tory should not

11、be considered suspect unless they differ bymore than 1 %.8.1.2 ReproducibilityThe results submitted by two ormore laboratories should not be considered suspect unless theydiffer by more than 1.5 %.1This test method is under the jurisdiction of ASTM Committee E48 onBioenergy and Industrial Chemicals

12、from Biomass and is the direct responsibility ofSubcommittee E48.05 on Biomass Conversion.Current edition approved June 1, 2013. Published June 2013. Originallyapproved in 1990. Last previous edition approved in 2006 as E1358 - 97(2006).DOI: 10.1520/E1358-97R13.2For referenced ASTM standards, visit

13、the ASTM website, www.astm.org, orcontact ASTM Customer Service at serviceastm.org. For Annual Book of ASTMStandards volume information, refer to the standards Document Summary page onthe ASTM website.3The last approved version of this historical standard is referenced onwww.astm.org.4Harris, Robert

14、 A., “Rapid Determination of Wood Fuel Moisture Using aMicrowave Oven for Drying,” Forest Products Journal, Vol 32, No. 10, October1982, pp. 5659.Copyright ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959. United States19. Keywords9.1 microwave oven; moisture

15、content; particulate woodfuelsASTM International takes no position respecting the validity of any patent rights asserted in connection with any item mentionedin this standard. Users of this standard are expressly advised that determination of the validity of any such patent rights, and the riskof in

16、fringement of such rights, are entirely their own responsibility.This standard is subject to revision at any time by the responsible technical committee and must be reviewed every five years andif not revised, either reapproved or withdrawn. Your comments are invited either for revision of this stan

17、dard or for additional standardsand should be addressed to ASTM International Headquarters. Your comments will receive careful consideration at a meeting of theresponsible technical committee, which you may attend. If you feel that your comments have not received a fair hearing you shouldmake your v

18、iews known to the ASTM Committee on Standards, at the address shown below.This standard is copyrighted by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959,United States. Individual reprints (single or multiple copies) of this standard may be obtained by contac

19、ting ASTM at the aboveaddress or at 610-832-9585 (phone), 610-832-9555 (fax), or serviceastm.org (e-mail); or through the ASTM website(www.astm.org). Permission rights to photocopy the standard may also be secured from the ASTM website (www.astm.org/COPYRIGHT/).TABLE 1 Recommended Heating TimesPine

20、HardwoodChips(AverageMoistureControl 48 %)Sawdust(AverageMoistureControl 46 %)Sawdust andBark (AverageMoistureControl 42 %)Hogged(AverageMoistureControl 23 %)Hogged(AverageMoistureControl 12 %)4:00 2:00 2:00 1:00 1:00AAAAA1:00 2:00 1:00 1:00 1:000:30 2:00 1:00 1:00 0:30in addition toAA AA0:30 0:30 0:30 in addition toAA Ain addition to in addition to in addition toARemove from oven, weigh, and stir.E1358 97 (2013)2

展开阅读全文
相关资源
猜你喜欢
相关搜索

当前位置:首页 > 标准规范 > 国际标准 > ASTM

copyright@ 2008-2019 麦多课文库(www.mydoc123.com)网站版权所有
备案/许可证编号:苏ICP备17064731号-1