CEN TS 16209-2011 Furniture - Classification for properties for furniture surfaces《家具 分类属性家具表面》.pdf
《CEN TS 16209-2011 Furniture - Classification for properties for furniture surfaces《家具 分类属性家具表面》.pdf》由会员分享,可在线阅读,更多相关《CEN TS 16209-2011 Furniture - Classification for properties for furniture surfaces《家具 分类属性家具表面》.pdf(14页珍藏版)》请在麦多课文档分享上搜索。
1、raising standards worldwideNO COPYING WITHOUT BSI PERMISSION EXCEPT AS PERMITTED BY COPYRIGHT LAWBSI Standards PublicationDD CEN/TS 16209:2011Furniture Classification for properties for furniture surfacesDD CEN/TS 16209:2011 DRAFT FOR DEVELOPMENTNational forewordThis Draft for Development is the UK
2、implementation of CEN/TS 16209:2011.This publication is not to be regarded as a British Standard.It is being issued in the Draft for Development series of publications and is of a provisional nature. It should be applied on this provisional basis, so that information and experience of its practical
3、application can be obtained.Comments arising from the use of this Draft for Development are requested so that UK experience can be reported to the international organization responsible for its conversion to an international standard. A review of this publication will be initiated not later than 3 y
4、ears after its publication by the international organization so that a decision can be taken on its status. Notification of the start of the review period will be made in an announcement in the appropriate issue of Update Standards.According to the replies received by the end of the review period, t
5、he responsible BSI Committee will decide whether to support the conversion into an international Standard, to extend the life of the T e c h n i c a l S p e c i f i c a t i o n o r t o w i t h d r a w i t . C o m m e n t s s h o u l d b e s e n t to the Secretary of the responsible BSI Technical Com
6、mittee at British Standards House, 389 Chiswick High Road, London W4 4AL.The UK participation in its preparation was entrusted to Technical Committee FW/0/1, Common Test Methods for Furniture.A list of organizations represented on this committee can be obtained on request to its secretary.This publi
7、cation does not purport to include all the necessary provisions of a contract. Users are responsible for its correct application. BSI 2011ISBN 978 0 580 73048 1ICS 97.140Compliance with a British Standard cannot confer immunity from legal obligations.This Draft for Development was published under th
8、e authority of the Standards Policy and Strategy Committee on 31 July 2011.Amendments issued since publicationDate T e x t a f f e c t e dDD CEN/TS 16209:2011TECHNICAL SPECIFICATION SPCIFICATION TECHNIQUE TECHNISCHE SPEZIFIKATION CEN/TS 16209 June 2011 ICS 97.140 English Version Furniture - Classifi
9、cation for properties for furniture surfaces Ameublement - Classification des proprits des surfaces dameublement Mbel - Klassifizierung von Mbeloberflchen This Technical Specification (CEN/TS) was approved by CEN on 3 April 2011 for provisional application. The period of validity of this CEN/TS is l
10、imited initially to three years. After two years the members of CEN will be requested to submit their comments, particularly on the question whether the CEN/TS can be converted into a European Standard. CEN members are required to announce the existence of this CEN/TS in the same way as for an EN an
11、d to make the CEN/TS available promptly at national level in an appropriate form. It is permissible to keep conflicting national standards in force (in parallel to the CEN/TS) until the final decision about the possible conversion of the CEN/TS into an EN is reached. CEN members are the national sta
12、ndards bodies of Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and
13、 United Kingdom. EUROPEAN COMMITTEE FOR STANDARDIZATION COMIT EUROPEN DE NORMALISATION EUROPISCHES KOMITEE FR NORMUNG Management Centre: Avenue Marnix 17, B-1000 Brussels 2011 CEN All rights of exploitation in any form and by any means reserved worldwide for CEN national Members. Ref. No. CEN/TS 162
14、09:2011: EDD CEN/TS 16209:2011CEN/TS 16209:2011 (E) 2 Contents Page Foreword 3Introduction .41 Scope 52 Normative references 53 Terms and definitions .54 Classification 54.1 General 54.2 Classification of the resistance to dry heat 64.3 Classification of the resistance to wet heat 64.4 Classificatio
15、n of the resistance to cold liquids 74.5 Classification of the resistance to abrasion .84.6 Classification of the resistance to scratching 85 Expression of results 8Bibliography 9DD CEN/TS 16209:2011CEN/TS 16209:2011 (E) 3 Foreword This document (CEN/TS 16209:2011) has been prepared by Technical Com
16、mittee CEN/TC 207 “Furniture”, the secretariat of which is held by UNI. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. CEN and/or CENELEC shall not be held responsible for identifying any or all such patent rights. According to t
17、he CEN/CENELEC Internal Regulations, the national standards organizations of the following countries are bound to announce this Technical Specification: Austria, Belgium, Bulgaria, Croatia, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy,
18、Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland and the United Kingdom. DD CEN/TS 16209:2011CEN/TS 16209:2011 (E) 4 Introduction This document is a working document for the classification of the resistance of furnit
19、ure surfaces according to the following properties: Resistance to dry heat Resistance to wet heat Resistance to cold liquids Resistance to abrasion Resistance to scratching NOTE Classification for other important properties for furniture surfaces, such as adhesion or light fastness, are included in
20、EN ISO 2409:2007 and EN 15187:2006. DD CEN/TS 16209:2011CEN/TS 16209:2011 (E) 5 1 Scope This Technical Specification specifies a system for the classification of the resistance to: Dry heat Wet heat Cold liquids Abrasion Scratching For resistance to dry heat, resistance to wet heat, and resistance t
21、o cold liquids, this Technical Specification applies to all furniture surfaces regardless of materials, except finishes on leather and fabrics. The classification for the surface resistance to abrasion applies to foil, laminate, melamine faced boards, pigmented and transparent coatings. It does not
22、apply to the surfaces covered by EN 14434. The classification for the surface resistance to scratching has two methods, A and B. Method A applies to all types of surface coatings and coverings except for melamine faced boards and HPL. Method B applies to all types of surfaces. It does not apply to f
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
本资源只提供5页预览,全部文档请下载后查看!喜欢就下载吧,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- CENTS162092011FURNITURECLASSIFICATIONFORPROPERTIESFORFURNITURESURFACES 家具 分类 属性 表面 PDF

链接地址:http://www.mydoc123.com/p-592618.html