1、AMSC N/A FSC 5930 MIL-DTL-13625/2B 21 January 2009 SUPERSEDING MIL-DTL-13625/2A 27 March 2003 DETAIL SPECIFICATION SHEET SWITCHES, PULL; SWITCHES, PUSH; SWITCHES, BEAM SELECTING, HEADLIGHT: ELECTRICAL (28 VOLTS DC MAXIMUM, FOR MILITARY VEHICLES) This specification is approved for use by all Depart-
2、ments and Agencies of the Department of Defense. The requirements for acquiring the product described herein shall consist of this specification and MIL-DTL-13625. FIGURE 1. INCH-POUND Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-DTL-13625/2B
3、2 Notes: 1. Type V (Single Pole, Single Throw, pull-latch disconnect, normally closed), Class A (slow make and break), Grade 2 (open) of procurement specification. 2. 300 Amp resistive load, 150 Amp inductive load. 3. Force required to operate the switch shall be 13 2 pounds. 4. Shall withstand a mi
4、nimum overload force of 150 pounds without damage. 5. Shall not exceed a maximum weight of 17 ounces. 6. Nut shall not be coated with Black Oxide. 7. Threads shall be in accordance with screw thread standard for FED-STD-H28. 8. Dimensions are in inches. Unless otherwise specified, tolerances are .01
5、 on decimals, 0 30 on angles. 9. For design feature purposes, this specification sheet takes precedence over procurement documents referenced herein. 10. This specification sheet is not intended to limit construction to features other than as shown heron by dimensions, notations or referenced docume
6、nts. 11. Referenced documents shall be of the issue in effect on the date on invitations for bid. 12. Marking shall consist of the part or identifying number (PIN) and Manufacturers identification in accordance with MIL-STD-130. FIGURE 1 continued. Supersedes Part or Identifying Number (PIN) MS Part
7、 No. Former Part No. MIL-DTL-13625/2-1 MS27200-1 8339369 The margins of this specification are marked with vertical lines to indicate where modifications from this amendment were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in thes
8、e notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marginal notations. Referenced documents: MIL-DTL-13625 MIL-STD-130 FED-STD-H28 Custodian: Preparing activity: Army - AT DLA - CC DLA CC (Project 5930-2008
9、083) NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil/ . Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
