1、AMSC N/A FSC 5930 INCH-POUND MS24613K 5 October 2011 SUPERSEDING MS24613J 30 September 1986 DETAIL SPECIFICATION SHEET SWITCH, TOGGLE, POSITIVE BREAK, LEVER LOCK, ENVIRONMENTALLY SEALED, SCREW TERMINAL, DOUBLE POLE, .469 MOUNTING BUSHING, 25 AMPERES This specification is approved for use by all Depa
2、rtments and Agencies of the Department of Defense. The requirements for acquiring the products described herein shall consist of this specification sheet and MIL-DTL-8834. FIGURE 1. Dimensions and configuration. Provided by IHSNot for ResaleNo reproduction or networking permitted without license fro
3、m IHS-,-,-MS24613K 2 FIGURE 1. Dimensions and configuration - Continued. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS24613K 3 MS dash number Superseded dash number sealed Environ- mental sealed Toggle Environ- mental Toggle Inches mm Inches mm
4、212 222 232 242 262 272 282 292 302 312 -21 -22 -23 -24 -26 -27 -28 -29 -30 -31 -21S -22S -23S -24S -26S -27S -28S -29S -30S -31S -211 -221 -231 -241 -261 -271 -281 -291 -301 -311 .005 .012 .047 .072 .138 .250 .430 0.13 0.30 1.19 1.83 3.51 6.35 10.92 .432 .469 .480 .921 1.015 1.203 1.336 10.97 11.91
5、 12.19 23.39 25.78 30.56 33.93 Example of Part or Identifying Number (PIN): MS24613B212 = on-off-on, environmentally sealed, locked in center off position. MS24613F272 = mom-on, off, mom-on, environmentally sealed, locked in center off position. The MS dash numbers supersede and are completely inter
6、changeable with the superseded dash numbers. NOTES: 1. Dimensions are in inches. 2. Metric equivalents are given for general information only. 3. Unless otherwise specified, tolerances are .010 (0.25 mm) on decimals and 5 on angles. FIGURE 1. Dimensions and configuration - Continued. REQUIREMENTS: F
7、or hardware and terminal screw detail specifications, see appendix of MIL-DTL-8834. In the event of a conflict between the text of this specification and the references cited herein, the text of this specification shall take precedence. The superseded dash numbers are inactive for design after 20 Ju
8、ly 1962. Maximum weight: .1453 pound 65.9 grams). Unlocking force = 4 1 pound. Altitude requirements: 80,000 feet. 115 V ac 60 hertz electrical endurance tests are to be performed at room temperature and pressure. Provided by IHSNot for ResaleNo reproduction or networking permitted without license f
9、rom IHS-,-,-TABLE I. Detail requirements. MS dash no. Locking comb. Circuit made between terminals as indicated with the toggle lever in these positions: Current capacity amperes per pole 28 volts dc Current capacity amperes per pole 115 volts 400 hertz Circuit capacity amperes per pole 115 volts 60
10、 hertz Lamp load circuit Resis-tive circuit Induc-tive circuit Lamp load circuit Resis-tive circuit Induc-tive circuit Lamp load circuit Resis-tive circuit Induc-tive circuit Environ- mentally sealed Opposite keyway side Center position Keyway side 212 A, B, C, D, E on 2-3, 5-6 off on 1-2, 4-5 7 25
11、15 7 25 15 7 20 15 222 C, E none off 232 on 1-2, 4-5 242 J, B off none 262 L none mom-on 1-2, 4-5 272 F, H mom-no 2-3, 5-6 off 282 K none 292 L on 2-3, 5-6 none mom-off 302 off mom-on 1-2, 4-5 312 G, K, M, N on 2-3, 5-6 off 1/ See footnote at end of table. 4MS24613KProvided by IHSNot for ResaleNo re
12、production or networking permitted without license from IHS-,-,-MS24613K 5 TABLE I. Detail requirements - Continued MS dash no. Current capacity amperes per pole 250 volts 60 Hertz ac 1/ Current capacity amperes per pole 125 volts dc 1/ Circuit capacity amperes per pole 250 volts ac 1/ Life low curr
13、ent level switching 30 mV Environ- mentally sealed Lamp load circuit Resis-tive circuit Induc-tive circuit Lamp load circuit Resis-tive circuit Induc-tive circuit Lamp load circuit Resis-tive circuit Induc-tive circuit 212 10 7 750 mA - 500 mA - 10 mA 222 232 242 262 272 282 292 302 312 1/ Applicati
14、on information ratings at room temperature. Referenced document: MIL-DTL-8834 Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect to the previous issue due to the extent of the changes. Custodians: Preparing activity: Army - CR DLA CC Navy -
15、 AS Air Force - 85 (Project 5930-2011-083) DLA - CC Review activities: Army - AR, MI Navy - EC Air Force - 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
