DLA SMD-5962-04230 REV C-2013 MICROCIRCUIT DIGITAL-LINEAR A D CONVERTER 14-BIT 80 MSPS MONOLITHIC SILICON.pdf
《DLA SMD-5962-04230 REV C-2013 MICROCIRCUIT DIGITAL-LINEAR A D CONVERTER 14-BIT 80 MSPS MONOLITHIC SILICON.pdf》由会员分享,可在线阅读,更多相关《DLA SMD-5962-04230 REV C-2013 MICROCIRCUIT DIGITAL-LINEAR A D CONVERTER 14-BIT 80 MSPS MONOLITHIC SILICON.pdf(17页珍藏版)》请在麦多课文档分享上搜索。
1、 REVISIONS LTR DESCRIPTION DATE (YR-MO-DA) APPROVED A Add device type 02 and RHA designator “R” requirements. Make changes to 1.2.2, 1.4, and Table I. Make a change to case outline X pin 32 under Figure 2. Add paragraphs 1.5, 4.4.4.1, and Table IIB. Delete AVCC, DVCC, and tCMINtests as specified und
2、er Table I. - ro 08-10-31 R. HEBER B Add device type 03 tested at low dose rate. Make change to paragraphs 1.2.2, 1.4, and 1.5. Make changes to footnotes 1/, 2/, and 3/ as specified under Table I. Make change to Table IIB and paragraph 4.4.4.1. -rrp 11-06-14 C. SAFFLE C Add single event latchup (SEL
3、) testing information for device types 02 and 03. Add paragraph 1.4.1. Delete device class M references. - ro 13-06-18 C. SAFFLE REV SHEET REV C C SHEET 15 16 REV STATUS REV C C C C C C C C C C C C C C OF SHEETS SHEET 1 2 3 4 5 6 7 8 9 10 11 12 13 14 PMIC N/A PREPARED BY DAN WONNELL DLA LAND AND MAR
4、ITIME COLUMBUS, OHIO 43218-3990 http:/www.landandmaritime.dla.mil STANDARD MICROCIRCUIT DRAWING THIS DRAWING IS AVAILABLE FOR USE BY ALL DEPARTMENTS AND AGENCIES OF THE DEPARTMENT OF DEFENSE CHECKED BY RAYMOND MONNIN APPROVED BY RAYMOND MONNIN MICROCIRCUIT, DIGITAL-LINEAR, A/D CONVERTER, 14-BIT, 80
5、MSPS, MONOLITHIC SILICON DRAWING APPROVAL DATE 04-10-25 AMSC N/A REVISION LEVEL C SIZE A CAGE CODE 67268 5962-04230 SHEET 1 OF 16 DSCC FORM 2233 APR 97 5962-E439-13 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-STANDARD MICROCIRCUIT DRAWING SIZE A
6、5962-04230 DLA LAND AND MARITIME COLUMBUS, OHIO 43218-3990 REVISION LEVEL C SHEET 2 DSCC FORM 2234 APR 97 1. SCOPE 1.1 Scope. This drawing documents two product assurance class levels consisting of high reliability (device class Q) and space application (device class V). A choice of case outlines an
7、d lead finishes are available and are reflected in the Part or Identifying Number (PIN). When available, a choice of Radiation Hardness Assurance (RHA) levels is reflected in the PIN. 1.2 PIN. The PIN is as shown in the following example: 5962 R 04230 02 V X C Federal stock class designator RHA desi
8、gnator (see 1.2.1) Device type (see 1.2.2) Device class designator Case outline (see 1.2.4) Lead finish (see 1.2.5) / (see 1.2.3) / Drawing number 1.2.1 RHA designator. Device classes Q and V RHA marked devices meet the MIL-PRF-38535 specified RHA levels and are marked with the appropriate RHA desig
9、nator. A dash (-) indicates a non-RHA device. 1.2.2 Device type(s). The device type(s) identify the circuit function as follows: Device type Generic number Operating temperature Circuit function 01 AD6645 -35C TC +85C A/D converter, 14-bit, 80 MSPS 02 AD6645 -55C TA +125C Radiation hardened A/D conv
10、erter, 14-bit, 80 MSPS 03 AD6645 -55C TA +125C Radiation hardened A/D converter, 14-bit, 80 MSPS 1.2.3 Device class designator. The device class designator is a single letter identifying the product assurance level as follows: Device class Device requirements documentation Q or V Certification and q
11、ualification to MIL-PRF-38535 1.2.4 Case outline(s). The case outline(s) are as designated in MIL-STD-1835 and as follows: Outline letter Descriptive designator Terminals Package style X See figure 1 52 Quad flat pack with non-conductive tie bars 1.2.5 Lead finish. The lead finish is as specified in
12、 MIL-PRF-38535 for device classes Q and V. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-STANDARD MICROCIRCUIT DRAWING SIZE A 5962-04230 DLA LAND AND MARITIME COLUMBUS, OHIO 43218-3990 REVISION LEVEL C SHEET 3 DSCC FORM 2234 APR 97 1.3 Absolute max
13、imum ratings. 1/ Analog supply voltage (AVCC) 0 V dc to 7 V dc Digital supply voltage (DVCC) . 0 V dc to 7 V dc Analog input voltage . 0 V dc to AVCCAnalog input current . 25 mA Digital input voltage 0 V dc to AVCCDigital output current 4 mA Junction temperature (TJ) . +175C Lead temperature (solder
14、ing, 10 seconds) . +300C Storage temperature range . -65C to +150C Thermal resistance, junction-to-case (JC) . 7.2C/W 1.4 Recommended operating conditions. Analog supply voltage (AVCC) 4.75 V dc to 5.25 V dc Digital supply voltage (DVCC) . 3.0 V dc to 3.6 V dc Case operating temperature range (TC) f
15、or device type 01 -35C to +85C Ambient operating temperature range (TA) for device types 02 and 03 . -55C to +125C 1.4.1 Operating performance characteristics. AC performance: TA= +25C, AVCC= 5 V, DVCC= 3.3 V, fC= 82 MSPS, fIN= 175 MHz. Signal to noise ratio (SNR) at -1 dBFS . 71 dB Signal to noise
16、and distortion (SINAD) at -1 dBFS . 70 dB Worst case second or third harmonic (2nd to 3rd) at -1 dBFS -78 dBc Worst case fourth or higher harmonic (4th plus) at -1 dBFS . -91 dBc 1.5 Radiation features: Maximum total dose available (dose rate = 50 300 rads(Si)/s): Device type 02 100 krads(Si) 2/ Max
17、imum total dose available (dose rate 10 mrads(Si)/s): Device type 03 50 krads(Si) 3/ Single event phenomenon (SEP): No single event latchup (SEL) occurs at effective linear energy transfer (LET) (see 4.4.4.2): Device types 02 and 03: . 80 MeV-cm2/mg 4/ _ 1/ Stresses above the absolute maximum rating
18、 may cause permanent damage to the device. Extended operation at the maximum levels may degrade performance and affect reliability. 2/ These parts may be dose rate sensitive in a space environment and may demonstrate enhanced low dose rate effects. Radiation end point limits for the noted parameters
19、 are guaranteed only for the conditions as specified in MIL-STD-883, method 1019, condition A. 3/ For device type 03, radiation end point limits for the noted parameters are guaranteed for the conditions specified in MIL-STD-883, method 1019, condition D. 4/ Limits are characterized at initial quali
20、fication and after any design or process changes that may affect the SEP characteristics, but are not production lot tested unless specified by the customer through the purchase order or contract. For more information on single event effect (SEE) test results, customers are requested to contact the
21、manufacturer. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-STANDARD MICROCIRCUIT DRAWING SIZE A 5962-04230 DLA LAND AND MARITIME COLUMBUS, OHIO 43218-3990 REVISION LEVEL C SHEET 4 DSCC FORM 2234 APR 97 2. APPLICABLE DOCUMENTS 2.1 Government specif
22、ication, standards, and handbooks. The following specification, standards, and handbooks form a part of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract. DEPARTMENT OF DEFENSE SPECIFICATION MIL-PRF-
23、38535 - Integrated Circuits, Manufacturing, General Specification for. DEPARTMENT OF DEFENSE STANDARDS MIL-STD-883 - Test Method Standard Microcircuits. MIL-STD-1835 - Interface Standard Electronic Component Case Outlines. DEPARTMENT OF DEFENSE HANDBOOKS MIL-HDBK-103 - List of Standard Microcircuit
24、Drawings. MIL-HDBK-780 - Standard Microcircuit Drawings. (Copies of these documents are available online at http:/quicksearch.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.) 2.2 Non-Government publications. The following documen
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
本资源只提供5页预览,全部文档请下载后查看!喜欢就下载吧,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DLASMD596204230REVC2013MICROCIRCUITDIGITALLINEARADCONVERTER14BIT80MSPSMONOLITHICSILICONPDF

链接地址:http://www.mydoc123.com/p-698295.html