1、 ENGINEERING STANDARDS Test Procedure SUPERCEDED EDS-T-4526 Test Procedure of Seat Back Pocket Strength This standard may be applied only for current projects. It is Superceded for all future projects and replaced by GMW15114. Seat Back Pocket I$ 4G 98 88x 7 , F6* 72T8p) F$ . 1.1 +95 . Seat Back Poc
2、ket8 I$ G88x +958p) F$ . 1.2 957 -88 . Seat Back Pocket8 .=%P +& Seat7 957F$ . 2 4) E:4 / :0 : C-H +d%P 9I8 6# F 48 07 38%P E:48x 957F$ . 2.1 17 E:4 / . None 2.2 GM E:4 / . None 2.3 dA E:4 / . None 3 4G 88 3.1 4G 8/x . 3.1.1 Seat* 4= M8 9IF3L 8# Jig. 3.1.2 3LD 9I-L . 3.1.3 F:E 84 8? . F:E8x 84F# 8?)
3、 0.5 Kgf8!* ?U9I F 3L 866 F$ . 3.1.4 F:E84 Jig. ,* 1 0 M8t Jig* 87F$ . 3.2 4G D . 4E ASSY 1B8 Seat* 3P 81 4G F$ . GM KOREA ENGINEERING STANDARDS EDS-T-4526 Copyright 2011 General Motors Company All Rights Reserved September 2011 Page 2 of 3 Version : 3 Figure 1 / ,* 1 4 Procedures 4.1 Conditions. 4.
4、1.1 Test Conditions. Deviations from the requirements of this standard shall have been agreed upon. Such requirements shall be specified on component drawings, test certificates, reports, etc. 4.2 Instructions. 4.2.1 Fix the seat fixture jig onto the groove plate and install the seat onto the jig. 4
5、2.2 After fixing the seat back to the design standard position, install the loading device and jig as shown in Figure 2 to apply horizontal load of 20 Kgf to the seat back pocket center and then check damage of the pocket. 4 4G 9) 9P9I / -PF%L6$ . Issue / P9I8)Y Publication Date / 38 88 Description (Organization) / 9PP9I76 (:04.2P ) 3 SEP 2011 Apply new Engineering Standard Template. Superceded (Interior Subsystem Validation Team) / 4 d3TE:4 64 957 . F9I957 =* (Interior.ED4D4 )
