1、GM DAEWOO Auto operating temperature items may be changed by the drawing condition under agreement with test division. (2) If no specified rules apply, the measurement should proceed at 3-test voltage within operating voltage range. 6.2.3. Current Leakage (1) Measurement must be done from battery po
2、wer line with real load at standard test voltage 12.6 0.1V. (2) Ignition power line must be OFF for this measurement. (3) If no specified rules apply, the measurement of Current Leakage must not exceeds 5. 6.3. Electric Tolerance Test 6.3.1. Power Voltage Variation Test (1) This test is to check the
3、 Unit and Handset normally operate when electric shock caused by Power voltage alteration occurs. (2) The DUT must be equal to design spec, and following test voltage should be 10cycles to the Battery however it must unavoidably performed out when failure occur DNU Hot&Cold Chamber GPS Ant. Artifici
4、al Satellite 016 PCS Net Small Center THE ELECTRIC COMPONENTS TEST FOR DREAM NET UNIT EDS-T-5441PAGE: 10/10 ISSUED DATE: 2001.12. 18 REVISED DATE: 2008. 10. 21 VERSION: 3 GM DAEWOO Auto & Technology during test. 7. Unit Test item by each DUT Table 1. DUT for each Test item Test Item S1 S 2 S 3 S 4 S 5 S 6 S7 S8 S9 S10 S S 6.1 X X X X X X X X X X X 6.2 X X X X X X X X X X X 6.3 X X X X X 6.7 X X X X X 6.4.4 X X X X X 6.4.6 X X X X X 6.4.7 X X X X X 6.5 X X X 6.4.1 X X X 6.4.2 X X X 6.4.3 X X X 6.4.8 X X X 6.4.9 X X X 6. X X X Note) 1 X, as stated above is unit test item of each DUT.
