IS 13727-1993 Requirements of cluster planning for housing Guide.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

EN 4176-2005 en Aerospace series - Lockbolts 100 countersunk normal head or protruding head tension- sheartype close tolerance in titanium alloy TI-P64001 anodized or with alumini.pdf

EN 4178-2009 0625 Aerospace series - Screws pan head six lobe recess coarse tolerance normal shank medium length thread in titanium alloy anodized MoS2 lubricated - 1 100 MPa (at a.pdf

EN 4178-2017 en Aerospace series - Screws pan head six lobe recess coarse tolerance normal shank medium length thread in titanium alloy anodized MoS2 lubricated - Classification 1 .pdf

EN 4179-2009 7500 Aerospace series - Qualification and approval of personnel for non-destructive testing《航空航天系列 无损检验人员的资格和审批》.pdf

EN 4179-2017 en Aerospace series - Qualification and approval of personnel for non-destructive testing《航空航天系列-无损检验人员的资格和认可》.pdf

EN 4180-2001 en Areospace Series - Circular Tubes for Fluids in Titanium and Titanium Alloys - Wide Tolerances - Diameter 4 mm Less Than or Equal to D Less Than or Equal to 40 mm -.pdf

EN 4182-2001 en Aerospace Series - Pipe Coupling 8 Degrees 30 in Titanium Alloy - Tees Reduced《航空航天系列 钛合金管连接830- 异径三通管》.pdf

EN 4183-2001 en Aerospace Series - Pipe Coupling 8 Degrees 30 in Titanium Alloy - Elbows 90 Degree Welded Ends《航空航天系列 钛合金管连接件830′ 弯头90焊接端》.pdf

EN 4184-2001 en Aerospace Series - Pipe Coupling 8 Degrees 30 in Titanium Alloy - Elbows 45 Degree Welded Ends《航空航天系列 钛合金管连接件830- 45弯头双焊接端头》.pdf