MSZ 2279-1979 《六角高大封闭B的精度等级》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

BS EN 10029-2010 Hot-rolled steel plates 3 mm thick or above Tolerances on dimensions and shape《厚度3 mm或3 mm以上热轧钢板材尺寸规格 形状和质量公差规范》.pdf

BS EN 10031-2003 Semi finished products for forging Tolerances on dimensions shape and mass《锻造用半成品 形状 质量和尺寸规格公差》.pdf

BS EN 10034-1993 Structural steel I and H sections - Tolerances on shape and dimensions《工字型和 H 型结构钢 形状和尺寸公差》.pdf

BS EN 10036-1991 Chemical analysis of ferrous materials - Determination of total carbon in steels and irons - Gravimetric method after combustion in a stream of oxygen《黑色金属材料的化学分析 .pdf

BS EN 10048-1997 Hot rolled narrow steel strip - Tolerances on dimensions and shape《热轧窄钢带 尺寸和形状公差》.pdf

BS EN 10049-2013 Measurement of roughness average $iR$ia and peak count $iR$iP$ic on metallic flat products《金属扁平制品平均粗糙程度Ra和峰值计数RPc的测量》.pdf

BS EN 10051-2010 Continuously hot-rolled strip and plate sheet cut from wide strip of non-alloy and alloy steels Tolerances on dimensions and shape《非合金钢和合金钢连续热轧的未涂覆板材 薄板材和带材规范 尺寸规格.pdf

BS EN 10055-1996 Hot rolled steel equal flange tees with radiused root and toes - Dimensions and tolerances on shape and dimensions《带圆角齿根和齿顶的热轧钢等边二层交错凸缘 尺寸和形状及尺寸公差》.pdf

BS EN 10056-1-2017 Structural steel equal and unequal leg angles Dimensions《等角和非等角结构钢 尺寸》.pdf