1、MIL-C-LbbYSA (Y) U3 999990b OY43882 O MIL-C- 16645A(SHIPS) AMENDMENT ,- 3 26 May 1961 MILITARY SPECIFICATION COMPRESSORS, RECIPROCATING, E ECTRIC MOTOR DRIVEN, NAVAL SHIPBOARD DIESEL ENGINE AIR STARTING SERVICE This amendment forms a part of Military Specification MIL- C- 16645A (SHiPS), 29 April 19
2、55. Page 3, paragraph 2. 1 continued: Under Navy Department Specifications delete reference to “General Specifications for Inspection of Material. If Page 3, paragraph 2. 1 continued: Under Publications add: “BUREAU OF SHIPS INAVSHIPS 250-637-2 - Instructions for Torch Brazing of Ferrous “NAVSHIPS 2
3、50-648-8 - Inspection and Test of Silver-Brazed Piping and Non-Ferrous Piping. Sy stem s. Ir Page 4, paragraph 3. 1: Delete. Page 6, paragraph 3. 3. 12. 1: Delete “basis“ and substitute “basesf1. Page 8, paragraph 3. 3. 17. 1; line 8: Insert “and in“ before “technical manual s . Page 8, paragraph 3.
4、 3. 18: Add as last sentence “Silver brazed joints For joints 1/2 inch and shall be in accordance with NAVSHIPS 250-637-2. above, preinserted ring fittings shall be used. face feed fittings may be used. For sizes below 1/2 inch, Page 14, Table II: Under “A“, second column: Delete “Valves, dis- charg
5、e, for all stages“ and “Valves, inlet, for all stages“. Page 14, Table II: Add the following: “E - 300 percent for all compressors: Valves, air cylinder, wearing parts only. II IFSC 43101 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-C-LbbqSA (
6、VI V3 m 399990b OVV3883 2 m MIL- C- 16645A(SHIPS) ALVENDMENT - 4 Page 16, paragraph 4. 1 through 4. 1. 1: Delete and substitute: It4. 1 Unless otherwise specified in the contract or purchase order, the supplier is responsible for the performance of all inspection requirements as specified herein. Th
7、e government reserves the right to perform any of the inspections set forth in the specification where such inspections are deemed necessary to assure supplies and services conform to prescribed requirement s. “ Page 17, paragraph 4.2, line 2: Delete “by the Government inspector“. Page 17, paragraph
8、 4. 3: Delete and substitute: “4. 3 Acceptance tests. -If Page 17, paragraph 4. 3. 1, lines 1 and 2: Delete “at the place of manufacture I. Page 17: Add the following paragraph as 4.3. 1. 1: “4. 3. 1. 1 Inspection and test of joints in systems designated as hazardous in manual NAVSHIPS 250-648-8 sha
9、ll be in accordance with the requirements of that manual. It Page 19, paragraph 4.4,4, line 2: Delete “by the Government inspector! Page 19, paragraph 4.4.5, line 2: Delete “by the Government inspector“. Page 21, paragraph 4.5: Delete. Pages 22 and 23, paragraph 6. 1 (e): Delete ttwhen“ and substitute what I I. Page 23, paragraph 6.2: Delete. Preparing activity: Navy - Ships (Project 43 1 O - NO26 Sh) Page 2 of 2 pages Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
