1、 c- 15-0.3 MI L- H- 60648 (OS) AMENDMENT 1 15 JULY 1986 1 f ! j ! ! I i i I i j I i i I i ; I ! I ! MILITARY SPECIFICATION HOLDER, STRIP, LOADED ASSEMBLY, M8, M9, M10, XM12, M19, OR XM25 AIRCRAFT EJECTION SEAT CATAPULT This amendment forms a part of Military Specification MIL-H-60648(MU), dated 17
2、March 1967, and is approved for use within the Naval Sea Systems Command, Department of the Navy, and is available for use by all Departments and Agencies of the Department of Defense. PAGE 1 2.1 Delete “MIL-P.-17689 . . . “through ! . . Type HE-N12“. Delete “MIL-STD-639 Surface Roughness Values Pre
3、ferred for Army Ordnance Material“ PAGE 2 Add: “2.2 Other publications. The following document forms a part of this specification to the extent specified herein. Unless otherwise specified, the issues of the document which are DOD adopted shall be those listed in the issue of the DODISS specified in
4、 the solicitation. specified, the issues of documents not listed in the DODISS shall be the issue of the nongovernment documents which is current on the date of the solicitation. Unless otherwise Beneficial comments (recommendations, pertinent data which may be of use in be addressed to: Commanding
5、Officer, Standardization Branch (5241) , Indian Head, MD 20640-5000, by using the self-addressed Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of the specification or by letter. AMSC N/A DISTRIBUTION STATEMENT A: Approved for public release; distribut f THIS DOCUM
6、ENT CONTAINS &? PAGES, FSC 1377 on is unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MlL-H-60648(OS) AMENDMENT 1 15 JULY 1986 ANSI 646.1-78 Surface Texture (Surface Roughness, Waviness and Lay) (Application for copies should be addressed
7、to the American National (Nongovernment standards and other publications are normally available Standards Insti tute (ANSI), 1430 Broadway, NY 10018.) from the organization which prepares or which distributes the documents. These documents also may be available in or through libraries or other infor
8、mati onal services. ) I PAGE .5 4.3.2, last sentence, delete “The Ordnance Standard Finish Blocks prescribed in MIL-STD-639 . . .I and substitute “The roughness comparison standards prescribed in ANSI 46.1-78 . . . . Il Preparing Activity: Navy - OS Project No. 1377-N818 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
