NF H44-001-1981 Aerosol generators Terminology 《烟雾发生器 术语》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

EN 2466-2009 en Aerospace series - Steel FE-PA3901 (X2CrNi19-11) - Softened - Forgings - De Less than or equal to 100 mm《航空航天系列 钢FE-PA3901(X2CrNi19-11) 软化 锻造 De≤ 100 mm》.pdf

EN 2467-2007 en Aerospace series - Steel FE-PA3901 (X2CrNi18-9) - Air melted - Softened - Plate sheet and strip - 0 4 mm less than or equal to a less than or equal to 20 mm - 520 M.pdf

EN 2469-2007 en Aerospace series - Steel FE-PA3901 (X1CrNi18-10) - Air melted - Softened - Wires - 0 4 mm or = to D or = to 12 5 mm - 450 MPa or = to Rm or = to 650 MPa《航空航天系列 .pdf

EN 247-1997 en Heat Exchangers - Terminology《热交换器 术语》.pdf

EN 2478-2008 en Aerospace series - Steel FE-PL2107 (30NiCrMo16) - 1 220 MPa less than or equal to Rm less than or equal to 1 370 MPa - Bars - De less than or equal to 40 mm《航空航天系列 .pdf

EN 248-2002 en Sanitary Tapware - General specification for electrodeposited coatings of Ni-Cr《卫生设备配件 镍铬电镀层的一般规范》.pdf

EN 2480-2008 en Aerospace series - Steel FE-PL2108 (36NiCrMo16) - 1 250 MPa = Rm = 1 400 MPa - Bars - De = 75 mm《航空航天系列 FE-PL2108(36NiCrMo16)型钢 1250MPa=Rm=1400MPa 棒材 De=75 mm》.pdf

EN 2481-2010 en Aerospace series - Steel FE-PL2108 (35NiCrMo16) - 1 250 MPa Rm 1 400 MPa - Forgings - De 75 mm《航空航天系列 钢FE-PL2108（35NiCrMo16）- 1250兆帕=马币=1400 Mpa级 - 锻件 - 德=75毫米》.pdf

EN 2482-2010 en Aerospace series - Steel FE-PL2108 (35NiCrMo16) - 1 100 MPa Rm 1 300 MPa - Bars - De 100 mm《航空航天系列 钢FE-PL2108（35NiCrMo16）- 1100兆帕=马币=1300兆帕 - 酒吧 - 百毫米》.pdf