SNI 01-2602-1992 Fried fermented soya bean cake crackers《干制发酵大豆饼》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

SANS 10100-1-2000 The structural use of concrete Part 1 Design《混凝土的结构用途 第1部分：设计》.pdf

SANS 10101-2008 Standard nomenclature for stitches seams and stitchings《针缝、接缝及缝纫的标准名称》.pdf

SANS 10103-2008 The measurement and rating of environmental noise with respect to annoyance and to speech communication《造成干扰和影响语言交际的环境噪音的测量和评级》.pdf

SANS 10104-1991 Handrailing and balustrading (safety aspects)《扶栏和栏杆（安全层面）》.pdf

SANS 10111-2-2-1993 Engineering drawing Part 2 Geometrical tolerancing Section 2 Datums and datum-systems for geometrical tolerances《工程制图 第2部分 几何公差 第2节 几何公差基准数及基准系统》.pdf

SANS 10111-2-3-2008 Geometrical product specifications (GPS) - Geometrical tolerancing - Maximum material requirement (MMR) least material requirement (LMR) and reciprocity require.pdf

SANS 10111-2-4-2005 Geometrical Product Specifications (GPS) - Geometrical tolerancing - Positional tolerancing《几何产品（GPS）技术规范 几何公差 位置公差》.pdf

SANS 10111-2-5-1993 Engineering drawing Part 2 Geometrical tolerancing Section 5 Fundamental tolerancing principle《工程制图 第2部分 几何公差 第5节 基本公差原则》.pdf

SANS 10114-1-2005 Interior lighting Part 1 Artificial lighting of interiors《室内照明 第1部分：室内人工照明》.pdf