MNOSZ 2231-1951 《螺旋母》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

CNS 3-11-2005 Engineering drawings (Representation of diagrams)《工程制图(图表画法)》.pdf

CNS 3-12-1994 Engineering Drawing (Geometrical Tolerancing - Maximum Material Principle)《工程制图(几何公差–最大实体原理)》.pdf

CNS 3-13-1994 Engineering Drawing (Geometrical Tolerancing - Positional Tolerancing)《工程制图(几何公差–位置度公差之标注)》.pdf

CNS 3-14-1994 Engineering Drawing (Geometrical Tolerancing - Datums and Datum - Systems)《工程制图(几何公差–基准及基准系统之标注)》.pdf

CNS 3-15-1994 Engineering Drawing (Geometrical Tolerancing - Proportions and Dimensions for Symbols)《工程制图(几何公差–符号之比例及尺度)》.pdf

CNS 3-16-1994 Engineering Drawing (Geometrical Tolerancing - Principles and Methods of Verification)《工程制图(几何公差–检测原理与方法)》.pdf

CNS 3-2005 Engineering drawing (General principles of presentation)《工程制图（一般准则）》.pdf

CNS 3-3-2002 Engineering drawing( Method of indicating surface texture on drawings )《工程制图﹝表面符号﹞》.pdf

CNS 3-4-1999 Engineering drawings - Geometrical toleranicing《工程制图(几何公差)》.pdf