1、AMSC N/A FSC 5930 MS35058K 6 January 2006 SUPERSEDING MS35058J 15 November 1980 DETAIL SPECIFICATION SHEET SWITCH, TOGGLE ONE POLE, SEALED TOGGLE This specification is approved for use by all Departments and Agencies of the Department of Defense. The complete requirements for acquiring the switch de
2、scribed herein shall consist of this specification and the latest issue of MIL-DTL-83731. FIGURE 1 Dimensions and configurations INCH-POUND Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS35058K 2NOTES 1. All dimensions are in inches. 2. For hardwa
3、re and terminal screw detail specifications see supplement of MIL-DTL-83731. 3. Unless otherwise specifies, tolerance is .02 on two place decimals and .005 on three place decimals. FIGURE 1 Dimensions and configurations Continued REQUIREMENTS: All switches on this standard are designed so that the m
4、ovement of the switch mechanism is opposite to that of the toggle lever. Maximum weight is 0.10 pounds. Endurance: Electrical 10,000 Cycles. Endurance: Mechanical 20,000 Cycles. Referenced documents shall be of the issue in effect on the date of invitation for bid. For design feature purposes, this
5、standard takes precedence over procurement document referenced herein. Table I MS part numbers Former Ms Part No. MS Part No. Screw-Lug Terminal Solder-Lug Terminal 1/ Former AN Part No. Former Jan Type Designation MS35058-5 - AN3021-1 ST40 E MS35058-21 - MS35058-16 - ST42 - - AN3021-2 ST40 A MS3505
6、8-22 - MS35058-9 - ST42 MS35058-4 - AN3021-3 ST40D MS35058-23 - MS35058-15 - ST42D MS35058-1 - AN3021-10 - MS35058-24 - MS35058-12 - MS35058-3 - AN3021-12 - MS35058-25 - MS35058-14 - MS35058-6 - - ST40F MS35058-26 - MS35058-17 - ST42FMS35058-7 - AN3021-7 ST40G MS35058-27 - MS35058-18 - ST42G MS35058
7、2 - AN3021-11 - MS35058-28 - MS35058-13 - - - AN3021-9 ST40B MS35058-29 - MS35058-10 - ST42B - - AN3021-8 ST40C MS35058-30 - MS35058-11 - ST42C MS35058-8 - AN3021-6 ST40H MS35058-31 - MS35058-19 - ST42H 1/ These MS part numbers are superseded by part number MS35058-21 thru MS35058-31, as applicable
8、 By removing the screws and lockwashers from the applicable part, a switch with solder lug terminal is formed. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-TABLE II: Detail Requirements Current Capacity (amperes per pole) Circuit with toggle leve
9、r in Direct Current Alternating Current 400 Hertz Alternating current 60 Hertz Lamp-Load Circuit Resistive Circuit Inductive Lamp Load Circuit Resistive Circuit Inductive Circuit Resistive Circuit Inductive Circuit Lamp Load Circuit MS Part No. Keying Side Center Opposite Keying side 28 V 28 V 125 V
10、 250 V 28 V 125 V 250 V 115 V 115 V 115 V 115 V 220 V 115 V Lamp Load Volts MS35058-21 On Off On MS35058-22 Off None On 7 25 - - 15 - - 3 10 10 10 - 10 - MS35058-23 On None On MS35058-24 None Off On MS35058-25 None Mom-Off On MS35058-26 Mom-On None On MS35058-27 Mom-On Off Mom-On MS35058-28 Mom-on O
11、ff None 5 20 - - 10 - - 2 10 7 10 - 7 - MS35058-29 Mom-Off None On MS35058-30 Mom-on None Off MS35058-31 Mom-on Off On MS35058K 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MS35058K 4Referenced documents MIL-DTL-83731 Marginal notations are not
12、used in this revision to identify changes with respect to the previous issue due to the extent of the changes. Custodians: Preparing activity: Army CR DLA CC Navy AS Air Force 11 Project (5930-2005-020) DLA CC Review activities: Army AV, MI Navy EC Air Force 99 NOTE: The activities listed above were
13、 interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at http:/assist.daps.dla.mil/. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
