1、FORD MANUPACTURING STANDARDS SBl-24A 100% KEVLAR BEVERSIBLEHEAVYWEIGHTKNIT GLOVES SBl-24A MARCH 1992 Page 1 1. 2. 3. 4. 5. 6. 7. USAGE: These gloves are designed for use by employees needing a greater degree of cut and laceration protection. The use of these gloves must be approved by the Safety Uni
2、t. NATERIAL: Heavy WeightSmall Heavy Weight Large The glove body is to be knit of 3 ends of 20/4 100% pure unblended Kemlar yarn. All SB1:24-1 Kevlar kuit gloves shall have a minimum of 12 courses of rubber, cotton covered yarn knitted into the glove to form an incorporated wrist. Wrist hemming shal
3、l be 2/300 polyester yarn. SIZE: large shall be 10 l/2 inches (27Chmn) overall from tip of middle finger to glove base. Width of the palm at the thumb crotch shall be 4 l/2 inches (119mm) and the wrist shall be 2 inches (Slam) in length. Small shall be 8-3/4 inches (2221mm) overall from tip of middl
4、e finger to glove base. Width bf the palm at the thumb crotch shall be 4 inches (102mm) and the wrist shall be 2 inches (Slmm) in length. CONSTRUCTION: Gloves are to be produced seamless, reversible in style with the wrist incorporated on a knitting machine. WEIGHT OF EACH GLOVE Heavy Weight Small -
5、 37 grsms Heavy Weight Large - 42 grams . RECLAIMING : These gloves shall be impervious to proper laundering procedures over a prudent recycling span. It is recommended that these gloves not be patched. NANUFACTURERS RESPONSIBI&Y: All material supplied to this standard must be equivalent in all characteristics to the material upon which approval was originally granted, and shall be satisfactory for the intended application.
