1、 ENGINEERING MATERIAL SPECIFICATION Material Name Specification Number Date Action Revisions 2008 12 03 N-STATUS No Replacement L. Schmalz, FNA / M. Montgomery, FOE 2003 04 10 Revised Para 3.0 inserted; Para 3.1, 3.2, 3.3, 3.10, 3.11, 4 deleted 1998 05 06 Activated N.J. Komatsu Printed copies are un
2、controlled Page 1 of 2 Copyright 2008, Ford Global Technologies, Inc. FABRIC, SAMBUCA PATTERN, WOVEN JACQUARD, WSS-M1H749-A UNLAMINATED NOT TO BE USED FOR NEW DESIGN 1. SCOPE The material defined by this specification is a woven jacquard polyester face fabric. 2. APPLICATION This specification was r
3、eleased originally for material used as an interior trim fabric for 1999 CW162. 3. REQUIREMENTS In addition to the requirements listed herein, the fabric shall meet all requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.0 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part
4、 producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.4 FABRIC CONSTRUCTION 3.4.1 Fabric Count, +/- 5 % tolerance (ASTM D 3775) Warp 255 ends/10 cm Weft 180 picks/10 cm 3.4.2 Fabric Weight, range (FLTM BN 106-01) 275 - 315 g/m23.5 COMPOSITION (AST
5、M D 629) Fabric 100 % polyester ENGINEERING MATERIAL SPECIFICATION WSS-M1H749-A Page 2 of 2 Copyright 2008, Ford Global Technologies, Inc. 3.6 YARN CONSTRUCTION (ASTM D 1244) Warp 650 dtex f130 - 150 (air texturized, semi- dull, round) Weft 650 dtex f130 - 150 (air texturized, semi- dull, round) 3.7
6、 METHOD OF DYEING Yarn dyed or as approved by Materials Engineering 3.8 FINISHED OPERATIONS As approved by Materials Engineering 3.9 FLAMMABILITY (ISO 3795/SAE J369) Burn Rate, max 100 mm/minute Note: Not required on face fabric when used as a fully bonded composite. 5. GENERAL INFORMATION The information given below is provided for clarification and assistance in meeting the requirements of this specification: 5.1 Purchase departments will ensure that both materials defined in this specification and shipped to any one assembly plant will be produced by one supplier only.
