1、A.C.N. 006 893 232 Holden Limited NUMBER : HN 2385 Engineering Department SHEET : lof2 ELEASE : November 2001 REVIS I ON : MATE RIAL SPEC I FI CATI O N HOLDEN Property Colour Extrusion rate (1/8 inch orifice at gopsi, room temperature) Specific gravity % solids Tensile strength i) Initial (cured) i)
2、 After 7 days at 200C NAME: ADHESIVE- SI LI CON-I -PART-N EUTRAL CU RE Req u ire ment Grey or clear 90-1 50g/min Test method 1 .I 95 % min GM9010P ASTM D638 1OOOpsi min 700 min 1. SCOPE Elongation iii) Initial iv) After 7 days at 200C This specification describes the requirements for a 1 -part, mois
3、ture curing (neutral cure) silicon adhesive/sealant. This material is a high strength, non-flowable gel with 650 % 460 % excellent h ig h tem peratu re d u ra bi I i ty. 2. REFERENCES GMW 3059 HN 1000 3. PHYSICAL REQUIREMENTS See Table 1. Temperature operating range GM9010P I -35C to 200C ASTM D638
4、Table 1. ASTM D638 FORM : I:CentralLaboratoryStandardFormsMaterialSpecificationMatspec.doc A.C.N. 006 893 232 Holden Limited NUMBER : HN 2385 Engineering Department SHEET : 2of2 RELEASE : November 2001 MATERIAL SPECIFICATION REVISION : HOLDEN NAM E: ADHESIVE- SI LI CON-I -PART-N EUTRAL CU RE 4. 5. 6
5、 7. APPROVAL, INSPECTION AND REJECTION Refer HN 1000, Clauses A, C and G. HAZARDOUS MATERIALS Refer HN 1000, Clause H. RESTRICTED CHEMICALS Refer HN 1000, Clause J. APPROVED SUPPLIERS AND MATERIALS APPROVED SUPPLIER APPROVED MATERIAL Dow Corning 3145 RTV Prepared by: Mark Franke .- .,$ FORM : I:CentralLaboratoStandardFormsMaterialSpecicationMatspec.doc
