MSZ 9250 1-1980 《绝缘配位一般标准》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

CNS 4570-1981 Bolts for T-slots (T-slots Bolts)《T形槽螺栓》.pdf

CNS 4571-1981 T-Head Bolts with Large Heads《大T形头螺栓》.pdf

CNS 4572-1981 T-head Bolts for Drawing Instruments《T型头螺栓（绘图仪器用）》.pdf

CNS 4573-1981 Slotted Raised Countersunk Bolts for Drawing Instruments《有槽扁圆顶埋头螺栓（绘图仪器用）》.pdf

CNS 4574-1981 Cover Bolts《有盖螺栓》.pdf

CNS 4575-1978 Finishes and Tolerance of Bolts Screws and Nuts Primarily of Steels Exhibiting Toughness at Subzero Temperature and High Temperature Steels《螺钉螺帽及类似产品之加工精度及许可差（耐高、低温之菝.pdf

CNS 4576-1983 Bolted Connections with Reduced Body (Survey and Installation)《减径柄螺栓之结合法（概览，应用范围与装用实例）》.pdf

CNS 4577-1978 Bolted Connections with Reduced Body( Studies Relating to the Calculation of Bolted Connection)《减径柄螺栓之结合法–结合计算方法》.pdf

CNS 4578-1978 Bolted Connections with Reduced Booy Metric Thread with Large Clearence Nominal Values and Limits《减径柄螺栓之结合法–具大间隙之公制螺纹（标称尺寸与限界尺寸）》.pdf