79:2003 has the status of a British Standard ICS 11.120.20 BS EN 14079:2003 This British Standard was published under the authority of the Standards P
医用脱脂棉Tag内容描述：
1、79:2003 has the status of a British Standard ICS 11.120.20 BS EN 14079:2003 This British Standard was published under the authority of the Standards Policy and Strategy Committee on 13 May 2003 BSI 13 May 2003 ISBN 0 580 41801 4 National foreword This British Standard is the official English language version of EN 14079:2003. The UK participation in its preparation was entrusted by Technical Committee CH/205, Non-act。
2、79:2003 has the status of a British Standard ICS 11.120.20 BS EN 14079:2003 This British Standard was published under the authority of the Standards Policy and Strategy Committee on 13 May 2003 BSI 13 May 2003 ISBN 0 580 41801 4 National foreword This British Standard is the official English language version of EN 14079:2003. The UK participation in its preparation was entrusted by Technical Committee CH/205, Non-act。
3、ordance with a formal copyright agreement. This document may reside on a CENTRAL FILE SERVER or INTRANET SYSTEM only. Unless specific permission has been granted, this document MAY NOT be sent or given to staff members from other companies or organizations. Doing so would constitute a VIOLATION of SABS copyright rules. 2. Indemnity The South African Bureau of Standards accepts no liability for any damage whatsoever than may result from the use of this material or the information contain therein,。
4、ICS 11 120 20 C 48 中华人民共和国医药行业标准 YY 0331 2006 代替YY0331 2002 脱脂棉纱布 脱脂棉粘胶混纺纱布的 性能要求和试验方法 Performance requirements and test methods for absorbent cotton gauze and absorbent cotton and viscose gauze EN 14。
5、 ( ) () ( ) : (http:/www.standard.go.kr) ： ：1979 12 24 ：2007 10 4 ：2012 12 6 ： 20120679 ： 。
6、2007 前言本标准由国家认证认可监tf管理委员会提出并归口。
本标准由中华人民共和国河南出人境检验检疫局负责起萃，河南飘安集团有限公司参加起草。
本标准主要起草人z王建中、王胜启、邢卫国、陈文铃、张卫理、侯瑞尘、崔继茂。
本标准系首次发布的出入统检验检疫行业标准。
进出口医用脱脂棉检验规程1 范围本标准规定了迸出口医用脱脂棉的要求、抽样、检验和结果的判定.本标准适用于迸出口医用脱脂棉的检验。
2 规范性引用文件3. 1 4 要求要求包括包装要求、感官要求、4. 1 包装要求4. 1. 1 包装应符合合同或定货单的要求。
./ 4. 1. 2 包装应平整、1;1-古、密封、干燥、牢固，适于长途运输。
4. 1. 3 采用布包装时.1包针距不应超过4针/10cmo 4. 1. 4 包装标志应清晰、不退色。
4. 1. 5 若迸出口应用脱脂棉为元前脱脂棉，成注明灭菌方式和灭菌失效年、月。
4. 1. 6 标志应符合输入国家或地区的有关规定。
4.2 感宫要求医用脱脂棉应为柔软而富有.性的白色纯棉纤维，不应有下列缺陷:SN/T 1946一2007色m、污点、运斑、异物、蚊蜗飞虫、异昧、内包装标志不消晰、。
