SN ISO 291-1985 TextilesTests for colour fastnessSection X09 Colour fastness to formaldehyde《碎片和碎石大小 质量规定》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

DIN 8605-1976 Machine Tools Lathes of High Accuracy Swing up to 500 mm Turning Length up to 1500 mm Acceptance Conditions《机床 高精度车床 旋转直径至500mm 车床中心距至1500mm 验收条件》.pdf

DIN 8606-1976 Machine Tools Lathes of Normal Accuracy Swing up to 800 mm Acceptance Conditions《机床 标准精度车床 旋转直径至800mm 验收条件》.pdf

DIN 8607-1976 Machine Tools Lathes of Normal Accuracy Swing above 800 up to 1600 mm Acceptance Conditions《机床 旋转直径800 至1600mm标准精度车床 验收条件》.pdf

DIN 8609-1-1979 Machine tools vertical turning and boring lathes acceptance conditions general introduction《机床 立式车床镗床 验收条件 一般介绍》.pdf

DIN 8609-2-1979 Machine tools vertical turning and boring lathes with one column acceptance conditions《机床 单柱立式车镗床 验收条件》.pdf

DIN 8609-3-1979 Machine tools vertical turning and boring lathes with two columns acceptance conditions《机床 第3部分 立式车床和双柱式车床 验收条件》.pdf

DIN 8611-1-1976 Machine Tools Horizontal Single-spindle Automatic Lathes Acceptance Conditions《机床 卧式单轴自动车床 验收条件》.pdf

DIN 8611-2-1976 Machine Tools Horizontal Automatic Lathes Front-loaded Acceptance Conditions《机床 正面装载的卧式自动车床 验收条件》.pdf

DIN 8611-3-1976 Machine Tools Horizontal Automatic Lathes Swiss-Type Automatic Lathes Acceptance Conditions《机床 卧式自动车床 瑞士型自动车床 验收条件》.pdf