1、 Beneficial comments, recommendations, additions, deletions, clarifications, etc., and any data that may improve this document should be sent to: DLA Land and Maritime, ATTN: DLA Land and Maritime-VAT, P.O. Box 3990, Columbus, OH 43218-3990, or email mailto:CircuitProtectdscc.dla.mil. Since contact
2、information can change you may want to verify the currency of the address information using the ASSIST Online database at https:/assist.daps.dla.mil. AMSC N/A FSC 5920 INCH-POUND A-A-55493D 17 February 2011 SUPERSEDING A-A-55493C 6 July 2006 COMMERCIAL ITEM DESCRIPTION FUSE CARTRIDGE, SEMICONDUCTOR
3、TYPE, 150 VOLTS The General Services Administration has authorized the use of this commercial item description for all federal agencies. 1. SCOPE. This commercial item description (CID) covers the general requirements for 150 volt semiconductor type fuse cartridges. Fuse cartridges covered by this C
4、ID are intended for commercial/industrial applications. 2. CLASSIFICATION/PART OR IDENTIFICATION NUMBER (PIN). This CID uses a classification system which is included in the PIN as shown in the following example (see 7.1). AA55493 - 001 CID PIN Dash number (see table I) 3. SALIENT CHARACTERISTICS. 3
5、.1 Interface and physical dimensions. Fuse cartridges supplied to this CID shall be as specified herein (see figure 1 and figure 2). 3.2. Ampere rating. The ampere rating shall be as specified in table I. 3.3 Voltage rating. The voltage rating shall be 150 V ac maximum. 3.4 Short circuit interrupt r
6、ating. The short circuit interrupt shall be 100,000 amperes root mean square (RMS) symmetrical. 3.5 Maximum current clearing I2t. The maximum current clearing I2t shall be as specified in table I. 3.6 Marking. Fuse cartridges supplied to this CID shall be marked with the manufacturers (MFRs) standar
7、d commercial PIN. (NOTE: the part number marked on the unit pack shall be the CID PIN.) Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55493D 2 AA55493- Dimensions A B C 001 through 006 1.500 (38.10) .406 (10.31) .374 (9.50) 007 through 011 2.00
8、0 (50.80) .813 (20.65) .820 (20.83) .495 (12.57) Configuration A NOTES: 1. Dimensions are in inches. 2. Unless otherwise specified, tolerance is .005 inch (0.13 mm). FIGURE 1. Configuration A and dimensions. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IH
9、S-,-,-A-A-55493D 3 AA55493- Dimensions A B C D E F G H 012 through 014 1.626 (41.30) .837 (21.26) 1.911 (48.54) 1.869 (47.47) 2.194 (55.73) 2.151 (54.64) 2.657 1.130 (28.70) .810 (20.57) .880 (22.35) .745 (18.92) .312 .188 015 through 021 (67.49) 1.130 (28.70) .995 (25.27) .880 (22.36) .745 (18.92)
10、(7.92) (4.78) 022 through 023 1.255 (31.88) .837 (21.26) 2.379 (60.43) 1.932 (49.07) 2.568 (65.23) 2.495 (63.37) 3.500 1.505 38.23 1.101 27.97 1.000 .406 .251 024 1.257 (31.93) .963 (24.46) (88.90) 1.600 (40.64) 1.101 (27.97) (25.40) (10.31) (6.38) Configuration B NOTES: 1. Dimensions are in inches.
11、 2. Unless otherwise specified, tolerance is .005 inch (0.13 mm). FIGURE 2. Configuration B and dimensions. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55493D 4 TABLE I. Electrical characteristics. AA55493- Ampererating I2t (A2s) AA55493- Amp
12、ererating I2t (A2s) 001 5 150 013 80 41,000 002 10 255 014 100 75,000 003 15 310 015 125 110,000 004 20 330 016 150 175,000 005 25 372 017 200 210,000 006 30 400 018 250 355,000 007 35 975 019 300 460,000 008 40 1,200 020 350 570,000 009 45 1,570 021 400 640,000 010 50 1,810 022 500 710,000 011 60 2
13、,150 023 600 875,000 012 70 25,000 024 800 950,000 3.7 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or environmentally preferable materials should be used to the maximum extent possible provided that the material meets or exceeds the operational and maintenance
14、requirements, and promotes economically advantageous life cycle costs. 3.8 Workmanship. Fuse cartridges shall be processed in such a manner as to be uniform in quality and shall be free from other defects that will affect life, serviceability, or appearance. 4. REGULATORY REQUIREMENTS. The offeror/c
15、ontractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with 23.403 of the Federal Acquisition Regulation (FAR). 5. PRODUCT CONFORMANCE PROVISIONS 5.1 Product conformance. The products provided shall meet the salient characteristics of this CID, conform to
16、 the producers own drawings, specifications, standards, and quality assurance practices, and be the same product offered for sale in the commercial market. The Government reserves the right to require proof of such conformance. 5.2 Market acceptance. The following market acceptance criteria are nece
17、ssary to document the quality of the product to be provided under this CID: a. The company producing the item must have been producing a product meeting the requirements of this CID for at least 2 years. b. The company producing the item must have sold 1,000 units meeting this CID in the commercial
18、marketplace over the past 2 years. 6. PACKAGING. Preservation, packing, and marking shall be as specified in the contract or order. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55493D 5 7. NOTES. 7.1 PIN. The PIN should be used for Government
19、purposes to buy commercial products to this CID. See the classification section for PIN format example. 7.2 Environmentally preferable material. Environmentally preferable materials should be used to the maximum extent possible to meet the requirements of this specification. As of the dating of this
20、 document, the U.S. Environmentally Protection Agency (EPA) is focusing efforts on reducing 31 priority chemicals. The list of chemicals is available on their website at http:/www.epa.gov/osw/hazard/wastemin/priority.htm. Use of these materials on the list should be minimized or eliminated unless ne
21、eded to meet the requirements specified herein (see Section 3). 7.3 Commercial and Government Entity (CAGE) code. For ordering purposes, inventory control, and submission of these fuse cartridges to DLA Land and Maritime under the Military Parts control Advisory Group (MPCAG) evaluation program, CAG
22、E code 58536 should be used. 7.4 Source of documents. FEDERAL REGULATIONS FAR - Federal Acquisition Regulations (FAR). (Copies of this document are available online at https:/www.acquisition.gov/comp/far/index.html or from the U.S. Government Printing Office, 732 North Capital Street, NW, Washington
23、 D.C. 20401-0001.) 7.5 Ordering data. The contract or order should specify the following: a. CID document number, revision, and CID PIN. b. Product conformance provisions. c. Packaging requirements. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A
24、-55493D 6 7.6 Commercial products. As part of the market analysis and research effort, this CID was coordinated with the following manufacturers of commercial products. At the time of CID preparation and coordination, these manufacturers were known to have commercial products that would meet the req
25、uirements of this CID. (NOTE: This information should not be considered as a list of approved manufacturers or be used to restrict procurement to only the manufacturers shown.) MFRs CAGE MFRs name and address 067U2 DENCO Fuses, Incorporated 8244 S.W. 103 Avenue Miami, FL 33173-3906 Phone number: (30
26、5) 273-6226 Facsimile number: (305) 273-4335 E-mail: mailto: Uniform Resource Locator (URL): http:/ 71400 Cooper Bussmann, Incorporated P. O. Box 14460 St. Louis, MO 63178-4460 Phone number (636) 394-2877 Facsimile number (800) 544-2570 E-mail: mailto: URL: http:/ 75915 Littelfuse Incorporated 8755
27、 W. Higgins Road Chicago, IL 60631-2708 Phone number (800) 999-9445 Facsimile number (847) 391-0753 E-mail: mailto: URL: http:/ Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55493D 7 7.7 Part number (P/N) supersession data. These CID PINs super
28、sede the following MFRs P/Ns as shown. This information is being provided to assist in reducing proliferation in the Government inventory system. TABLE III. P/N supersession data. CID dash number (see table I) AA55493- Vendor Commercial P/N 1/ CAGE 067U2 CAGE 71400 CAGE 75915 001 UFR15P005 FWA-5A10F
29、 L15S5 002 UFR15P010 FWA-10A10F L10S10 003 UFR15P015 FWA-15A10F L15S15 004 UFR15P020 FWA-20A10F L15S20 005 UFR15P025 FWA-25A10F L15S25 006 UFR15P030 FWA-30A10F L15S30 007 UFR15P035 FWA-35A21F L15S35 008 UFR15P040 FWA-40A21F L15S40 009 UFR15P045 FWA-45A21F L15S45 010 UFR15P050 FWA-50A21F L15S50 011 U
30、FR15P060 FWA-60A21F L15S60 012 UFR15P070 FWA-70B L15S70 013 UFR15P080 FWA-80B L15S80 014 UFR15P100 FWA-100B L15S100 015 UFR15P125 FWA-125B L15S125 016 UFR15P150 FWA-150B L15S150 017 UFR15P200 FWA-200B L15S200 018 UFR15P250 FWA-250B L15S250 019 UFR15P300 FWA-300B L15S300 020 UFR15P350 FWA-350B L15S35
31、0 021 UFR15P400 FWA-400B L15S400 022 UFR15P500 FWA-500B L15S500 023 UFR15P600 FWA-600B L15S600 024 UFR15P800 FWA-800B L15S800 1/ The manufacturers P/N shall not be used for procurement to the requirements of this CID. At the time of preparation of this CID, the aforementioned commercial products wer
32、e reviewed and could be replaced by the CID PIN shown. For actual part marking requirements, see 3.6. 7.8 Government users. To acquire information on obtaining these fuse cartridges from the Government inventory system, contact DLA Land and Maritime, ATTN: DLA Land and Maritime-FMX, P.O. Box 3990, C
33、olumbus, OH 43218-3990, or telephone (614) 692-3677. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55493D 8 7.8.1 National stock number (NSN). The following is a list of NSNs assigned which correspond to this CID. The list is for information on
34、ly and may not be indicative of all possible NSNs associated with the CID. For up to date information on assigned NSNs, please contact the aforementioned DLA Land and Maritime office (See 7.8). TABLE IV. NSNs. Dash number (see table I) AA55493- NSN Dash number (see table I) AA55493- NSN 001 N/A 013
35、N/A 002 N/A 014 N/A 003 5920-00-070-4681 015 N/A 004 N/A 016 N/A 005 N/A 017 N/A 006 N/A 018 N/A 007 N/A 019 N/A 008 N/A 020 N/A 009 N/A 021 N/A 010 N/A 022 N/A 011 N/A 023 5920-01-158-9052 012 N/A 024 5920-01-262-0872 7.9 Changes from previous issue. Marginal notations are not used in this revision
36、 to identify changes with respect to the previous issue due to the extensiveness of the changes. MILITARY INTERESTS: CIVIL AGENCY COORDINATING ACTIVITY: GSA - FAS Custodians: Navy - EC Preparing activity: DLA - CC DLA-CC Project 5920-2011-027 NOTE: The activities listed above were interested in this
37、 document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
