1、MIL-F-44422 Ar4mwmm1 12 Januarv 1994 MILITARY SPECIFICATION FIBER RPE ASSEMBLY, INSERTIN/EX“TION This amenciment fonns a part of MIL-F-44422, dated 27 December 1990, and is approved for use by all Departments and Agencies of the Department of Defense. PAGE 1 1.2, lines 3, 4 and 5: Delete “+5%“ and s
2、ubstitute “+lo%“. PAGE 5 TABLE I, in last 2 columns opposite “Circumference in inches at load P“: _ Delete t 1/8“ anci substitute “_+3/16“. O PAGE 6 3.5.2, lines 1 thru 17: Delete and substitute: “bottan of the first loop, and then enter again through the center of the main rope three picks up from
3、the bottom of the first loop to form the first loop. Each white loop shall consist of 10 inches (2 1 inch) of exposed rope. main rope forming a loop, it shall be passed back through the center of the main rope one pick up, and then passed through the center of itself where it last entered the main r
4、ope. The white rope will then be passed through the center of the main rope two picks up fran the top of the last loop, then passed back through the center of the main rope two picks up from the last exit, then passed back through the center of itself, and passed back through the center of the main
5、rope one pick up fran where it had last passed through itself, forming the bottom of the second loop. follawed to make the second and third white loops. loop, the white nylon rope shall be passed through the center of the main After the white rope has been passed back through the center of the The s
6、ame procedure shall be After making the third AMSC N/A 1 of 3 FSC 4020 DISTRIBVTION STATEME“ A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-MIL-F-44422 (1) m 9999906 1974423 745 MIL-F-44422
7、AME“T1 PAGE 6 (contd) rope three and one-half picks up from the top of the third loop, and then eye spliced around the outer half of the main rope. Each eye splice in the white nylon rope shall consist of four full and two half tucks.“ 3.5.3: Delete and substitute: “3.5.3 Safety line rope. The black
8、 nylon safety line rope shall pass through the center of the main rope one and one-half picks above, and on the same side as, the upper eye splice of the extraction loops rope. nylon safety line rope shall then pass through the two securing passes of the extraction loops rope, on the same side of th
9、e main rope, then through the center of the main rope, one and one-half picks above the luwer eye splice of the extraction loops rope. line rope will then be passed through the securing passes on the opposite side of the first two, and the rope will then be spliced to itself with a short splice betw
10、een the top eye and the top securing pass. After being spliced together, the safety line rope shall extend out as far as all three extraction loops, when all three extraction loops are fully extended out at the same time, and shall not interfere with the extraction loops.“. The black After passing t
11、hrough the main rope, the safety PAGE 8 4.3, line 2: Delete “4.4.5“ and substitute “4.4.4“. Line 3: Delete “4.4.6“ and substitute “4.4.5“. 4.4.1.1, line 3: Delete “IV“ and substitute “III“. PAGE 9 4.4.2, line 3: Delete “V“ and substitute “IV“. 4.4.3, line 2: Delete “v“ and substitute “IV“. 2 Provide
12、d by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-Custodians: W-GL MIL-F-44422 (1) M 999990b 1974Y2Y 681 M MIL-F-44422 AMENDMENT1 Review activities: DIA - IS Navy - MC, SH Preparing activity: Army-& (Project 4020-0345) 3 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
