DLA SMD-5962-97571 REV A-2009 MICROCIRCUIT DIGITAL ADVANCED HIGH-SPEED CMOS QUADRUPLE 2-INPUT POSITIVE-NOR GATE TTL COMPATIBLE INPUTS MONOLITHIC SILICON.pdf
《DLA SMD-5962-97571 REV A-2009 MICROCIRCUIT DIGITAL ADVANCED HIGH-SPEED CMOS QUADRUPLE 2-INPUT POSITIVE-NOR GATE TTL COMPATIBLE INPUTS MONOLITHIC SILICON.pdf》由会员分享,可在线阅读,更多相关《DLA SMD-5962-97571 REV A-2009 MICROCIRCUIT DIGITAL ADVANCED HIGH-SPEED CMOS QUADRUPLE 2-INPUT POSITIVE-NOR GATE TTL COMPATIBLE INPUTS MONOLITHIC SILICON.pdf(17页珍藏版)》请在麦多课文档分享上搜索。
1、 REVISIONS LTR DESCRIPTION DATE (YR-MO-DA) APPROVED A Update the boilerplate paragraphs to current requirements as specified in MIL-PRF-38535. - jak 09-01-21 Charles F. Saffle REV SHET REV A A SHET 15 16 REV STATUS REV A A A A A A A A A A A A A A OF SHEETS SHEET 1 2 3 4 5 6 7 8 9 10 11 12 13 14 PMIC
2、 N/A PREPARED BY Joseph A. Kerby STANDARD MICROCIRCUIT DRAWING CHECKED BY Charles F. Saffle, Jr. DEFENSE SUPPLY CENTER COLUMBUS COLUMBUS, OHIO 43218-3990 http:/www.dscc.dla.mil THIS DRAWING IS AVAILABLE FOR USE BY ALL DEPARTMENTS APPROVED BY Monica L. Poelking AND AGENCIES OF THE DEPARTMENT OF DEFEN
3、SE DRAWING APPROVAL DATE 97-06-13 MICROCIRCUIT, DIGITAL, ADVANCED HIGH-SPEED CMOS, QUADRUPLE 2-INPUT POSITIVE-NOR GATE, TTL COMPATIBLE INPUTS, MONOLITHIC SILICON AMSC N/A REVISION LEVEL A SIZE A CAGE CODE 67268 5962-97571 SHEET 1 OF 16 DSCC FORM 2233 APR 97 5962-E126-09 Provided by IHSNot for Resale
4、No reproduction or networking permitted without license from IHS-,-,-STANDARD MICROCIRCUIT DRAWING SIZE A 5962-97571 DEFENSE SUPPLY CENTER COLUMBUS COLUMBUS, OHIO 43218-3990 REVISION LEVEL A SHEET 2 DSCC FORM 2234 APR 97 1. SCOPE 1.1 Scope. This drawing documents two product assurance class levels c
5、onsisting of high reliability (device classes Q and M) and space application (device class V). A choice of case outlines and lead finishes are available and are reflected in the Part or Identifying Number (PIN). When available, a choice of Radiation Hardness Assurance (RHA) levels is reflected in th
6、e PIN. 1.2 PIN. The PIN is as shown in the following example: 5962 - 97571 01 Q C A Federal stock class designator RHA designator (see 1.2.1) Device type (see 1.2.2)Device class designatorCase outline (see 1.2.4) Lead finish (see 1.2.5) / (see 1.2.3) / Drawing number 1.2.1 RHA designator. Device cla
7、sses Q and V RHA marked devices meet the MIL-PRF-38535 specified RHA levels and are marked with the appropriate RHA designator. Device class M RHA marked devices meet the MIL-PRF-38535, appendix A specified RHA levels and are marked with the appropriate RHA designator. A dash (-) indicates a non-RHA
8、 device. 1.2.2 Device type(s). The device type(s) identify the circuit function as follows: Device type Generic number Circuit function 01 54AHCT02 Quadruple 2-input positive-NOR gate, TTL compatible inputs 1.2.3 Device class designator. The device class designator is a single letter identifying the
9、 product assurance level as follows: Device class Device requirements documentation M Vendor self-certification to the requirements for MIL-STD-883 compliant, non-JAN class level B microcircuits in accordance with MIL-PRF-38535, appendix A Q or V Certification and qualification to MIL-PRF-38535 1.2.
10、4 Case outline(s). The case outline(s) are as designated in MIL-STD-1835 and as follows: Outline letter Descriptive designator Terminals Package style C GDIP1-T14 or CDIP2-T14 14 Dual-in-line D GDFP1-F14 or CDFP2-F14 14 Flat pack 2 CQCC1-N20 20 Square leadless chip carrier 1.2.5 Lead finish. The lea
11、d finish is as specified in MIL-PRF-38535 for device classes Q and V or MIL-PRF-38535, appendix A for device class M. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-STANDARD MICROCIRCUIT DRAWING SIZE A 5962-97571 DEFENSE SUPPLY CENTER COLUMBUS COLUM
12、BUS, OHIO 43218-3990 REVISION LEVEL A SHEET 3 DSCC FORM 2234 APR 97 1.3 Absolute maximum ratings. 1/ 2/ 3/ Supply voltage range (VCC) . -0.5 V dc to +7.0 V dc DC input voltage range (VIN) . -0.5 V dc to +7.0 V dc 4/ DC output voltage range (VOUT) -0.5 V dc to VCC+0.5 V dc 4/ DC input clamp current (
13、IIK) (VINVCC) 20 mA Continuous output current (IO) (VOUT= 0 V to VCC) . 25 mA Continuous current through VCCor GND 50 mA Maximum power dissipation at TA= +55C (instill air) (PD) . 500 mW 5/ Storage temperature range (TSTG) -65C to +150C Lead temperature (soldering, 10 seconds) +300C Thermal resistan
14、ce, junction-to-case (JC) . See MIL-STD-1835 Junction temperature (TJ) . +150C 1.4 Recommended operating conditions. 2/ 3/ 6/ Supply voltage range (VCC) . +4.5 V dc to +5.5 V dc Minimum high level input voltage (VIH) +2.0 V Maximum low level input voltage (VIL). +0.8 V Input voltage range (VIN) . +0
15、.0 V dc to +5.5 V dc Output voltage range (VOUT) +0.0 V dc to VCCMaximum high level output current (IOH) . -8 mA Maximum low level output current (IOL) . +8 mA Minimum input transition rise or fall rate (t/V) . 20 ns/V Case operating temperature range (TC) -55C to +125C 1/ Stresses above the absolut
16、e maximum rating may cause permanent damage to the device, Extended operation at the maximum levels may degrade performance and affect reliability. 2/ Unless otherwise noted, all voltages are referenced to GND. 3/ The limits for the parameters specified herein shall apply over the full specified VCC
17、range and case temperature range of -55C to +125C. 4/ The input and output voltage ratings may be exceeded providing that the input and output current ratings are observed. 5/ The maximum package power dissipation is calculated using a junction temperature of 150 C and a board trace length of 750 mi
18、ls. 6/ Unused inputs must be held high or low to prevent them from floating. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-STANDARD MICROCIRCUIT DRAWING SIZE A 5962-97571 DEFENSE SUPPLY CENTER COLUMBUS COLUMBUS, OHIO 43218-3990 REVISION LEVEL A SHE
19、ET 4 DSCC FORM 2234 APR 97 2. APPLICABLE DOCUMENTS 2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in th
20、e solicitation or contract. DEPARTMENT OF DEFENSE SPECIFICATION MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for. DEPARTMENT OF DEFENSE STANDARDS MIL-STD-883 - Test Method Standard Microcircuits. MIL-STD-1835 - Interface Standard Electronic Component Case Outlines. DEPAR
21、TMENT OF DEFENSE HANDBOOKS MIL-HDBK-103 - List of Standard Microcircuit Drawings. MIL-HDBK-780 - Standard Microcircuit Drawings. (Copies of these documents are available online at http:/assist.daps.dla.mil/quicksearch/ or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D,
22、 Philadelphia, PA 19111-5094.) 2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text of this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption ha
23、s been obtained. 3. REQUIREMENTS 3.1 Item requirements. The individual item requirements for device classes Q and V shall be in accordance with MIL-PRF-38535 and as specified herein or as modified in the device manufacturers Quality Management (QM) plan. The modification in the QM plan shall not aff
24、ect the form, fit, or function as described herein. The individual item requirements for device class M shall be in accordance with MIL-PRF-38535, appendix A for non-JAN class level B devices and as specified herein. 3.2 Design, construction, and physical dimensions. The design, construction, and ph
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
本资源只提供5页预览,全部文档请下载后查看!喜欢就下载吧,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- DLASMD596297571REVA2009MICROCIRCUITDIGITALADVANCEDHIGHSPEEDCMOSQUADRUPLE2INPUTPOSITIVENORGATETTLCOMPATIBLEINPUTSMONOLITHICSILICONPDF

链接地址:http://www.mydoc123.com/p-701212.html