NF D36-204 A1-1996 Lubricants for applications in appliances and associated controls using combustible gases except those designed for use in industrial processes 《NF EN 377-1993的修.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

NF C74-385-2005 Medical electrical equipment - Part 2-51 particular requirements for safety including essential performance of recording and analysing single channel and multichan.pdf

NF C74-390-1985 Electromedical equipment Diagnostic equipment from biopotentials other than cardiographic (ecg) Requirements for safety and operation for such equipment 《医用电气设备 除心电.pdf

NF C74-502-2-2-2008 Active implantable medical devices - Part 2-2 particular requirements for active implantable medical devices intended to treat tachyarrhythmia (includes implan.pdf

NF C75-100-1982 Hand-held motor operated tools Part 1 general requirements 《手提式电动机驱动式工具 第1部分 一般要求》.pdf

NF C75-303-2005 Safety of hand-held electric motor operated tools - Part 2-3 particular requirements for grinders disk type sanders and polishers 《手持式电动工具的安全 第2-3部分 研磨机、盘式砂轮机和抛光机的.pdf

NF C75-313-2006 Safety of hand-held electric motor operated tools - Part 2-13 particular requirements for chain saws 《手持式电动工具的安全性 第2-13部分 链锯的特殊要求》.pdf

NF C75-315-2006 Safety of hand-held electric motor operated tools - Part 2-15 particular requirements for hedge trimmers 《手持式电动工具安全性 第2-15部分 树篱修剪机的特殊要求》.pdf

NF C75-605-1994 Hand-held electric mains voltage operated circular saws Methods for measuring the performance 《手提式电源电压驱动式锯床 性能测量方法》.pdf

NF C75-745-2-5-2006 Hand-held motor-operated electric tools - Safety - Part 2-5 particular requirements for circular saws 《手持式电动工具 第2-5部分 圆盘锯的特殊要求》.pdf