1、SAE Technical Standards Board Rules providethat: “This report is published by SAE to advancethe state oftechnical and engineering sciences.Theuse ofthis reportisentirelyvoluntary, andits applicability and suitability for any particularuse,including any patentinfringement arising therefrom,isthe sole
2、 responsibility of the user.”SAE reviews each technical reportatleastevery five years atwhich timeitmay bereaffirmed,revised, or cancelled.SAE invites your written comments and suggestions.SHEET 1 OF 2AS33731AEROSPACE STANDARDAS33731ISSUED 1997-08 REAFFIRMED 2009-04STRIP, MOUNTING, NUT INSULATING,FO
3、R MS27212 TERMINAL BOARDPREPARED BY SUBCOMMITTEE AE-8C2FEDERAL SUPPLY CLASS 5970NOTICEThis document has been taken directly from U.S. Military Standard, MS3373C, and contains only minor editorial and format changes required to bring it into conformance with the publishing requirements of SAE technic
4、al standards.The original Military Standard was adopted as an SAE standard under the provisions of the SAE Technical Standards Board (TSB) Rules and Regulations (TSB 001) pertaining to accelerated adoption of government specifications and standards. TSB rules provide for (a) the publication of porti
5、ons of unrevised government specifications and standards without consensus voting at the SAE Committee level, (b) the use of the existing government specification or standard format, and (c) the exclusion of any qualified product list (QPL) sections.Copyright 2009 SAE International All rights reserv
6、ed. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission of SAE. TO PLACE A DOCUMENT ORDER: Tel: 877-606-7323 (inside USA and Canada
7、) Tel: 724-776-4970 (outside USA) Fax: 724-776-0790 Email: CustomerServicesae.org SAE WEB ADDRESS: http:/www.sae.org SAE values your input. To provide feedbackon this Technical Report, please visit http:/www.sae.org/technical/standards/AS33731 STRIP, MOUNTING, NUT INSULATING,FOR MS27212 TERMINAL BOA
8、RDAEROSPACE STANDARDAS33731SHEET 2 OF 2AS33731NOTES:1. MATERIAL INSULATOR STRIP: DIALLYL PHTHALATE PER MIL-P-19833, TYPE GDI-30F.2. DIMENSIONS IN INCHES. UNLESS OTHERWISE SPECIFIED, TOLERANCES: DECIMALS .010.3. REMOVE ALL BURRS AND SHARP EDGES, MOLD MARKS AND NORMAL VENT FLASH ARE PERMISSIBLE.4. IDENTIFICATION MARKING: EACH STRIP SHALL BE MARKED WITH THE MS PART NUMBER.5. EXAMPLE OF PART NO. MS3373-B1=A DUAL HOLE TYPE B PART, SIZE 1.
