1、A-A-55115 m 9999974 0145417 T53 m 3 1 s Beneficial comments (recommendations, additions, deletions) and any pertinent data which may be of use in improving this document should be addressed to: Defense Personnel Support Center, Clothing and Textiles Directorate, Attn: DPSC-FSSD, 2800 South 20th Stre
2、et, Philadelphia, PA 19101-8419, by using the Standardization Document Improvement Proposal (DD Form * A-A-5 5 11 5 August 31 1993 COMMERCIAL ITEM DESCRIPTION CLOTH, BROADCLOTH, POLYESTER AND COTTON The General Services Administration has authorized the use of this Commercial Item Description in pre
3、ference to MIL-C-43479. Abstract. This Commercial Item Description covers one type and six classes of polyester and cotton blended cloth. The cloth is intended for use in the manufacture of shirtwaists, shirts and lining material for sleeping bags. Classification. The cloth shall be in the following
4、 types and classes: - 2.8 to 3.6 oz/yd2 Type 1 Class 1 - White 3024 Class 2 - Dyed Class 3 - Dyed and treated with a durable press finish Class 4 - White 3024 treated with a durable press Class 5 - Dyed and water repellant treated Class 6 - Dyed, water repellant and downproof treated finish Type II
5、- 3.2 to 3.7 oz/yd2, end to end construction Class 3 - Dyed Description. Unless otherwise specified, the finished cloth shall be a minimum of 60 inches inclusive of selvage when fly shuttle looms or shuttleless with tuck-in selvage looms are used. For all other shuttleless looms the width measuremen
6、t shall be DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited. Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55115 9999974 Ol145Y18 99T = A-A-5 5 11 5 made between the last warp yarn on each side excluding the prot
7、ruding fringe(s). Standard samde. The finished cloth shall match the standard sample for shade and appearance and shall, unless otherwise indicated, be equal to or better than the standard sample with respect to all characteristics for which the standard sample is referenced. Yarns. The yarns shall
8、be a blend of polyester and combed cotton, drawn and spun into single yarns for both warp and filling. the remaining percentage cotton, based on the dry weight of the desized specimen. The finished cloth shall contain 65 2 5% polyester and Color. The color of the finished cloth shall be White 3024 f
9、or Type I, Classes 1 and 4. The cloth shall be fully bleached and may be supplemented with fluorescent optical brightener to the blue region. The color of the warp ends of the finished cloth for Type II class 3 shall be Air Force Blue 1550 and shall match the standard sample. The selvage of the clot
10、h shall be the same color as the base cloth. classes 2, 3, 5 and 6 shall be as specified in the contract and shall match the standard sample. pigments is prohibited. The color of the cloth for Type I, The use of resin bonded Labile sulfur (classes 2, 3, 5, and 61. The use of dyes and compounds conta
11、ining elementary sulfur capable of oxidation to sulfuric acid is prohibited The dyestuff shall be chosen and applied so that the cloth shall contain no more labile sulfur than shown by the standard sample when tested as specified in Table III. finished cloth shall show no more than a slight trace of
12、 labile sulfur when tested as specified in Table III. When a standard sample is not available, the dyed and Matchinq. The color of the finished cloth shall match the standard sample when viewed under filtered tungsten lamps which approximate artificial daylight having a correlated color temperature
13、of 7500 (2 200) Kelvin, with illumination of 100 (+ 20) foot candles and shall be a good match to the standard sample under incandescent lamplight at 2300 (2 200) Kelvin. Colorfastness. The dyed classes 2, 3, 5, and 6 finished cloth shall show fastness to laundering (after 3 cycles) perspiration and
14、 light equal to or better than the standard sample or equal to or better than a rating of “good“ when tested as specified in Table III. The dyed and finished class 5 cloth shall show “good“ I 2 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-5511
15、5 W 7q 01Y5Y29 826 = A-A- 5 5 11 5 fastness to light after 40 standard fading hours even when a standard sample is available. The dyed and finished classes 2, 3, 5 and 6 cloth shall show fastness to crocking equal to or better than the standard sample or shall have an AATCC Chromatic Transference Sc
16、ale rating not lower than 3.5 when tested as specified in Table III. * t Physical requirements. The finished cloth shall conform to the requirements listed in Table I. Table I Physical requirements Requirement Test Characteristic Yarn (types I shaded side to side, side to center or end to end; or no
17、t having the same appearance as the standard sample shall be cause for rejection of the entire lot represented by the sample. Lenqth examination. During the yard-by-yard examination, each roll in the sample shall be examined for length. Any lot found to be less than the minimum length specified in t
18、he basic cloth document or more than 2 yards less than the length marked on the ticket shall be scored as a defect. The lot shall be unacceptable if two or more rolls in the sample are defective in respect to the length. The lot shall be unacceptable if the total of the actual length of the rolls in
19、 the sample is less than the total of the lengths marked on the roll tickets. Roll examination. During the yard-by-yard examination, each roll in the sample shall be examined for the defects listed below. The lot shall be unacceptable if two or more of the defects are present in the sample: Contains
20、 identification of a preshrinkage process by name Face stamping missing from either or both ends. Not labeled or ticketed in accordance with the Rules and Regulations under the Textile Fiber Products Identification Act. or trademark on cloth or ticket. Preservation, Packinq and Markinq. The preserva
21、tion, packing and marking shall be as specified in the contract or order. 10 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-A-A-55115 W 7Li OlLi5427 7T2 A-A-5 5 11 5 Sources of Government Documents. Copies of Military and Federal I documents are ava
22、ilable from: Standardization Documents Order Desk Bldg. 4D 700 Robbins Avenue Philadelphia, PA 19111-5094 Rules And Regulations Under The Textile Fiber Products Identification Act (Copies may be obtained without charge from the Federal Trade Commission, Washington, DC 20850.) Sources of Non-qovernme
23、nt Documents. TECHNICAL MANAL OF THE AMERICAN ASSOCIATION OF TEXTILE CHEMISTS AND COLORISTS (AATCC) Method No. 8 - Crocking Method No. 118 - Oil Repellency: Hydrocarbon Resistance Test Method No. 124 - Appearance of Durable Press Fabric after Repeated Home Launderings (Applications for copies should
24、 be addressed to AATCC, P.O. Box 12215, Research Triangle Park, N.C. 27709) e Chromatic Transference Scale AATCC Chromatic Transference Scales are available from AATCC, P.O. Box 12215, Research Triangle Park, N.C. 27709. AMERICAN SOCIETY FOR TESTING AND MATERIALS (ASTM) Method No. 3775 - Fabric Coun
25、t of Woven Fabric Method No. 3776 - Mass Per Unit Area (Weight) of Woven Method No. 5034 - Breaking Force And Elongation of Textile Fabric Fabrics (Grab Test) (Applications for copies should be addressed to American Society For Testing and Materials, 1916 Race Street, Philadelphia, PA 19103.) Sears
26、Fabric Defect Scales are available from Sears, Roebuck and Company, Department 817 (Attn: BSC 23-29), “Sears Defect Replica Kit“, Sears Tower, Chicago, IL 60684. ADRrOVa1 of durable press resin, water repellant, and downproof finishes . Approval of the durable press resin and water repellant and dow
27、nproof finishes is the responsibility of the U.S. Army Natick f 11 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- A-A-55115 W 9999974 0145428 839 A-A-55 115 Research, Development and Engineering Center, Natick, MA 01760- 5014. Only those treatments
28、 approved and so listed in the invitation for bids or request for proposals shall be considered acceptable for the related procurement. Custodian: Navy - NU Army - GL User Activity: Navy - MC Civil Agency Coordinating Activity : GSA - FSS Preparing Activity: DLA - CT Project No. 8305-0496 12 Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
