ETSI TS 102 694-2-2015 Smart Cards Test specification for the Single Wire Protocol (SWP) interface Part 2 UICC features (V10 3 0 Release 10)《智能卡 单线协议 (SWP) 接口的试验规格 第2部分 UICC特征 (V10.pdf
《ETSI TS 102 694-2-2015 Smart Cards Test specification for the Single Wire Protocol (SWP) interface Part 2 UICC features (V10 3 0 Release 10)《智能卡 单线协议 (SWP) 接口的试验规格 第2部分 UICC特征 (V10.pdf》由会员分享,可在线阅读,更多相关《ETSI TS 102 694-2-2015 Smart Cards Test specification for the Single Wire Protocol (SWP) interface Part 2 UICC features (V10 3 0 Release 10)《智能卡 单线协议 (SWP) 接口的试验规格 第2部分 UICC特征 (V10.pdf(118页珍藏版)》请在麦多课文档分享上搜索。
1、 ETSI TS 102 694-2 V10.3.0 (2015-03) Smart Cards; Test specification for the Single Wire Protocol (SWP) interface; Part 2: UICC features (Release 10) TECHNICAL SPECIFICATION ETSI ETSI TS 102 694-2 V10.3.0 (2015-03)2Release 10Reference RTS/SCP-00SWPUva30 Keywords smart card, terminal ETSI 650 Route d
2、es Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N 348 623 562 00017 - NAF 742 C Association but non lucratif enregistre la Sous-Prfecture de Grasse (06) N 7803/88 Important notice The present document can be downloaded from: http:/www.etsi.org
3、/standards-search The present document may be made available in electronic versions and/or in print. The content of any electronic and/or print versions of the present document shall not be modified without the prior written authorization of ETSI. In case of any existing or perceived difference in c
4、ontents between such versions and/or in print, the only prevailing document is the print of the Portable Document Format (PDF) version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of sta
5、tus. Information on the current status of this and other ETSI documents is available at http:/portal.etsi.org/tb/status/status.asp If you find errors in the present document, please send your comment to one of the following services: https:/portal.etsi.org/People/CommiteeSupportStaff.aspx Copyright
6、Notification No part may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm except as authorized by written permission of ETSI. The content of the PDF version shall not be modified without the written authorization of ETSI. The copyr
7、ight and the foregoing restriction extend to reproduction in all media. European Telecommunications Standards Institute 2015. All rights reserved. DECTTM, PLUGTESTSTM, UMTSTMand the ETSI logo are Trade Marks of ETSI registered for the benefit of its Members. 3GPPTM and LTE are Trade Marks of ETSI re
8、gistered for the benefit of its Members and of the 3GPP Organizational Partners. GSM and the GSM logo are Trade Marks registered and owned by the GSM Association. ETSI ETSI TS 102 694-2 V10.3.0 (2015-03)3Release 10Contents Intellectual Property Rights 11g3Foreword . 11g3Modal verbs terminology 11g3I
9、ntroduction 11g31 Scope 12g32 References 12g32.1 Normative references . 12g32.2 Informative references 13g33 Definitions, symbols and abbreviations . 13g33.1 Definitions 13g33.2 Symbols 14g33.3 Abbreviations . 14g33.4 Formats . 15g33.4.1 Format of the table of optional features 15g33.4.2 Format of t
10、he applicability table . 15g33.4.3 Status and Notations . 15g34 Test environment 16g34.1 Table of optional features . 16g34.2 Applicability table 17g34.3 Information to be provided by the DUT supplier . 22g34.4 Test equipment . 22g34.4.1 Measurement/setting uncertainties 22g34.4.2 Default conditions
11、 for DUT operation 23g34.4.2.1 Temperature 23g34.4.2.2 ETSI TS 102 221 interface contacts (CLK, RST, I/O) and contact Vcc . 24g34.4.2.3 ETSI TS 102 600 interface contacts (IC_DP, IC_DM) . 24g34.4.2.4 ETSI TS 102 613 interface contact (SWIO) 25g34.4.2.5 Status of UICC interfaces 25g34.4.2.6 Character
12、istics of LLCs 25g34.4.2.6.1 ACT LLC 25g34.4.2.6.2 SHDLC LLC . 25g34.4.2.6.3 CLT LLC . 26g34.4.3 Minimum/maximum conditions for DUT operation . 26g34.4.3.1 Temperature 26g34.4.3.2 Contact Vcc. 26g34.5 Test execution 26g34.5.1 Parameter variations . 26g34.5.2 Execution requirements 26g34.6 Pass crite
13、rion 27g35 Test cases 27g35.1 Principle of the Single Wire Protocol . 27g35.2 System architecture 27g35.2.1 General overview 27g35.2.2 ETSI TS 102 221 support . 27g35.2.2.1 Conformance requirements . 27g35.2.3 Configurations 28g35.2.3.1 Conformance requirements . 28g35.2.3.2 Test case 1: Global Inte
14、rface bytes of the ATR 28g35.2.3.2.1 Test execution 28g35.2.3.2.2 Initial conditions 28g35.2.3.2.3 Test procedure . 28g35.2.3.3 Test case 2: interaction with ETSI TS 102 221 interface - SWP activation while the UICC receives data 28g35.2.3.3.1 Test execution 28g3ETSI ETSI TS 102 694-2 V10.3.0 (2015-
15、03)4Release 105.2.3.3.2 Initial conditions 28g35.2.3.3.3 Test procedure . 29g35.2.3.4 Test case 3: interaction with ETSI TS 102 221 interface - SWP activation while the UICC sends data 29g35.2.3.4.1 Test execution 29g35.2.3.4.2 Initial conditions 29g35.2.3.4.3 Test procedure . 29g35.2.4 Interaction
16、with other interfaces . 30g35.2.4.1 Conformance requirements . 30g35.2.4.2 Test case 1: interaction with ETSI TS 102 221 interface - ETSI TS 102 221 clock stop 30g35.2.4.2.1 Test execution 30g35.2.4.2.2 Initial conditions 30g35.2.4.2.3 Test procedure . 30g35.2.4.3 Test case 2: interaction with ETSI
17、TS 102 221 interface - ETSI TS 102 221 reset 30g35.2.4.3.1 Test execution 30g35.2.4.3.2 Initial conditions 30g35.2.4.3.3 Test procedure . 31g35.2.4.4 Test case 3: interaction with ETSI TS 102 221 interface - SWP deactivation while the UICC receives data 31g35.2.4.4.1 Test execution 31g35.2.4.4.2 Ini
18、tial conditions 31g35.2.4.4.3 Test procedure . 31g35.2.4.5 Test case 4: interaction with ETSI TS 102 221 interface - SWP deactivation while the UICC sends data 31g35.2.4.5.1 Test execution 31g35.2.4.5.2 Initial conditions 32g35.2.4.5.3 Test procedure . 32g35.2.4.6 Test case 5: interaction with ETSI
19、TS 102 221 interface - reset SWP while the UICC receives data 32g35.2.4.6.1 Test execution 32g35.2.4.6.2 Initial conditions 32g35.2.4.6.3 Test procedure . 32g35.2.4.7 Test case 6: interaction with ETSI TS 102 221 interface - reset SWP while the UICC sends data 33g35.2.4.7.1 Test execution 33g35.2.4.
20、7.2 Initial conditions 33g35.2.4.7.3 Test procedure . 33g35.2.4.8 Test case 7: interaction with ETSI TS 102 221 interface - activate SWP in ETSI TS 102 221 clock stop 33g35.2.4.8.1 Test execution 33g35.2.4.8.2 Initial conditions 33g35.2.4.8.3 Test procedure . 33g35.3 Physical characteristics . 34g35
21、.3.1 Temperature range for card operations . 34g35.3.1.1 Conformance requirements . 34g35.3.2 Contacts 34g35.3.2.1 Provision of contacts . 34g35.3.2.1.1 Conformance requirements 34g35.3.2.2 Contact activation and deactivation 34g35.3.2.2.1 Conformance requirements 34g35.3.2.3 Interface activation 34
22、g35.3.2.3.1 Conformance requirements 34g35.3.2.3.2 Test case 1: initial activation in low power mode . 35g35.3.2.3.3 Test case 2: initial activation in low power mode with corrupted frames . 36g35.3.2.3.4 Test case 3: no activation. 36g35.3.2.3.5 Void . 37g35.3.2.3.6 Test case 5: full power mode act
23、ivation 37g35.3.2.3.7 Test case 6: low power mode activation with re-transmission of ACT_SYNC. 37g35.3.2.3.8 Test case 7: full power mode activation with re-transmission of ACT_SYNC . 38g35.3.2.3.9 Void . 38g35.3.2.3.10 Test case 9: low power mode activation with multiple re-transmission of ACT_SYNC
24、 38g35.3.2.3.11 Test case 10: full power mode activation with re-transmission of ACT_READY 39g35.3.2.3.12 Test case 11: full power mode activation with multiple re-transmission of ACT_SYNC . 39g3ETSI ETSI TS 102 694-2 V10.3.0 (2015-03)5Release 105.3.2.3.13 Test case 12: subsequent activation in low
- 1.请仔细阅读文档,确保文档完整性,对于不预览、不比对内容而直接下载带来的问题本站不予受理。
- 2.下载的文档,不会出现我们的网址水印。
- 3、该文档所得收入(下载+内容+预览)归上传者、原创作者;如果您是本文档原作者,请点此认领!既往收益都归您。
本资源只提供5页预览,全部文档请下载后查看!喜欢就下载吧,查找使用更方便
10000 积分 0人已下载
下载 | 加入VIP,交流精品资源 |
- 配套讲稿:
如PPT文件的首页显示word图标,表示该PPT已包含配套word讲稿。双击word图标可打开word文档。
- 特殊限制:
部分文档作品中含有的国旗、国徽等图片,仅作为作品整体效果示例展示,禁止商用。设计者仅对作品中独创性部分享有著作权。
- 关 键 词:
- ETSITS10269422015SMARTCARDSTESTSPECIFICATIONFORTHESINGLEWIREPROTOCOLSWPINTERFACEPART2UICCFEATURESV1030RELEASE10

链接地址:http://www.mydoc123.com/p-739383.html