JUS H B1 013-1981 Sulphuric acid for use in leadacid batteries Technical requirements《铅酸电池用硫酸 技术要求》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

BS EN ISO 2814-2007 Paints and varnishes - Comparison of contrast ratio (hiding power) of paints of the same type and colour《涂料和清漆 同类型颜色涂料对比率(遮盖力)》.pdf

BS EN ISO 2815-2003 Paints and varnishes - Buchholz indentation test《涂料和清漆 布赫兹(Buchholz)压痕试验》.pdf

BS EN ISO 2818-1996 Plastics - Preparation of test specimens by machining《塑料 试样的机加工制备》.pdf

BS EN ISO 2825-2010 Spices and condiments - Preparation of a ground sample for analysis《香料和调料 分析用研磨样品的制备》.pdf

BS EN ISO 283-2015 Textile conveyor belts Full thickness tensile strength elongation at break and elongation at the reference load Test method《纺织品输送带 全厚度拉伸强度、断裂伸长和基准荷载延伸 试验方法》.pdf

BS EN ISO 284-2012 Conveyor belts Electrical conductivity Specification and test method《输送带 导电率 规格和试验方法》.pdf

BS EN ISO 2858-2010 End-suction centrifugal pumps (rating 16 bar) Designation nominal duty point and dimensions《端吸离心泵(额定压强 16 bar) 命名 公称负荷点和尺寸规格》.pdf

BS EN ISO 286-1-2010 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Basis of tolerances deviations and fits《几何产品规范（GPS） 线性尺寸公差的ISO编码系统 .pdf

BS EN ISO 286-2-2010 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Tables of standard tolerance classes and limit deviations for holes.pdf