SNI ISO 16070-2015 Industri minyak dan gas bumi - Peralatan dalam sumur - Lock mandrels dan landing nipples.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

ONORM M 1345-1995 Control of measuring and test equipment Testing instruction for dial test indicators (lever type) for linear measurement《试验设备监控 触杆测量仪的检验指南》.pdf

ONORM M 1346-1-1995 Control of measuring and test equipment - Testing Instruction for plug gauges《测量控制及测试设备 柱形测孔规测试说明》.pdf

ONORM M 1346-2-1995 Control of measuring and test equipment - Testing instruction for ring gauges and setting ring gauges《测量控制及测试设备 环规测试说明和安装环规》.pdf

ONORM M 1347-1995 Control of measuring and test equipment - Testing Instruction for gap gauges《测量控制及测试设备 间隙规测试说明》.pdf

ONORM M 1348-1995 Control of measuring and test equipment - Testing instruction for electrical linear measuring probes《测量控制及测试设备 电动线性测量探针测试说明》.pdf

ONORM M 1349 AC1-1999 Verification of measuring and test equipment - Testing Instruction for measuring tapes (Corrigendum)《测量设备和测试设备的检定 测尺的测试说明（勘误）》.pdf

ONORM M 1349-1997 Verification of measuring and test equipment - Testing Instruction for measuring tapes《测量设备和测试设备的检定 测尺的测试说明》.pdf

ONORM M 1362-1984 Edges of workpieces terms indications in drawings《工件边沿 条款，图示说明》.pdf

ONORM M 1365 Teil 1-1990 General tolerances tolerances for linear and angular dimensions without individual tolerance indications above 4000 mm up to 25000 mm《一般公差 4000 mm到25000 mm.pdf