TIS 1650-1998 Motorcycles safety requirements emission from engine level 4《摩托车 安全性要求 发动机排放 4级》.pdf

相关资源

IRS 70778-2-2018 Recommendations for determining the carrying capacity and fatigue risks of existing metallic railway bridges.pdf

IRS 70712-2018 Rail defects.pdf

IRS 50596-6-2018 Conditions for coding intermodal loading units in combined transport combined transport lines and wagons.pdf

IRS 50596-5-2018 Transport of road vehicles on wagons-Technical Organisation-Conveyance of semi-trailers with P coding or N coding on recess wagons.pdf

IESNA TM-23-2017 Lighting Control Protocols.pdf

IESNA RP-2-2017 Recommended Practice for Retail Lighting.pdf

ITU-R RAPPORT M 766-2 FRENCH-1990 Feasibility of frequency sharing between the GPS and other services《全球定位系统和其他服务之间的频率共享的可行性》.pdf

ITU-R RAPPORT M 763-3 FRENCH-1990 Signal level variation due to multipath effects and blockage by ship-s superstructure in maritime mobile-satellite service lin.pdf

ITU-R RAPPORT M 739-1 FRENCH-1986 Interference due to intermodulation products in the land mobile service between 25 and 100 MHz《由于互调产物在陆地移动服务25和100 MHz之间产生的干扰》.pdf

ITU-R RAPPORT M 319-7 FRENCH-1990 Characteristics of equipment and principles governing the assignment of frequency channels between 25 and 100 MHz for land mob.pdf

猜你喜欢

SIS SS 2107-1990 ISO system of limits and fits ISO tolerances EF3 to EF10 for holes《ISO限制和配合体系 ISO孔公差EF3－EF10》.pdf

SIS SS 2108-1990 ISO system of limits and fits ISO tolerances F3 toFlO for holes《ISO限制和配合体系 ISO孔公差F3 -FlO》.pdf

SIS SS 2109-1990 ISO system of limits and fits ISO tolerances FG3 toFGW for holes《ISO限制和配合体系 ISO孔公差FG3 至FGW》.pdf

SIS SS 2110-1990 ISO system of limits and fits SO tolerances G3 to G10 for holes《ISO限制和配合体系 ISO孔公差G3 －G10》.pdf

SIS SS 2111-1990 ISO system of limits and fits ISO tolerances H1 to HI8 for holes《ISO限制和配合体系 ISO孔公差H1 －H18》.pdf

SIS SS 2112-1990 ISO system of limits and fits ISO tolerances J6toJ18 for holes《ISO限制和配合体系 ISO孔公差JS6－JS18》.pdf

SIS SS 2113-1990 ISO system of limits and fits ISO tolerances JS1toJS18 for holes《ISO限制和配合体系 ISO孔公差JS1－ JS18》.pdf

SIS SS 2114-1990 ISO system of limits and fits ISO tolerances K3 toK10 for holes《ISO限制和配合体系 ISO孔公差K3 -K10》.pdf

SIS SS 2115-1990 ISO system of limits and fits ISO tolerances M3 toM10 for holes《ISO限制和配合体系 ISO孔公差m3 – m10》.pdf