1、AMSC N/A FSC 5930 INCH-POUND MS25452H 6 December 2010 SUPERSEDING MS25452G 1 February 2006 DETAIL SPECIFICATION SHEET GUARD, SWITCH, 2 POSITION, LOCK This specification is approved for use by all Departments and Agencies of the Department of Defense. The complete requirements for acquiring the switc
2、h described herein shall consist of this specification and the latest issue of MIL-DTL-7703. DASH NO. TYPE PANEL THICKNESS (REF) OPERATING FORCE -1 3-HOLE MOUNTING .050 TO .081 .3 TO 1.5 LBS FIGURE 1 Dimensions and configuration Provided by IHSNot for ResaleNo reproduction or networking permitted wi
3、thout license from IHS-,-,-MS25452H 2 Inches mm Inches mm Inches mm Inches mm .005 0.13 .062 1.57 .161 4.09 .750 22.22 006 0.20 .081 2.06 .516 13.11 1.250 31.75 .010 0.25 .094 2.39 .594 15.09 1.750 44.45 .016 0.41 .151 3.83 .703 17.86 1.812 46.02 .032 0.81 .156 3.96 .719 18.29 2.125 53.98 .050 1.27
4、NOTES: 1. Unless otherwise specifies, tolerances are .016 on decimals. 2. Material: Steel, commercial, shall be smooth and free from burrs. 3. Finish: Zinc plate, ASTM-B633 , type III, or cadmium plate, SAE-AMS-QQ-P-416, type III, with optional supplementary treatment per MIL-C-8514 or DOD-P-15328,
5、black enamel, lusterless, color number FED-STD-595 /37038 or semi gloss, color number FED-STD-595 /27038 or equivalent. 4. For design feature purposes, this standard takes precedence over procurement documents referenced herein. FIGURE 1.Dimensions and configuration Continued REQUIREMENTS Guard shal
6、l remain in only the closed position. Opening the guard shall not change the position of the toggle lever. Closing the guard with the lever in the up position locks lever in the up position. The guard in the closed position shall exert no pressure o the toggle. Part or Identifying Number (PIN) MS254
7、52-1 replaces and is completely interchangeable with PIN N3229-1. Referenced documents MIL-DTL-7703 MIL-C-8514 ASTM-B633 SAE-AMS-QQ-P-416 FED-STD-595/27038 FED-STD-595/37038 DOD-P-15328 Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where mo
8、difications from this revision were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of th
9、e marginal notations. Custodians: Preparing activity Army CR DLA CC Navy AS (Project 5930-2011-026) Air Force 11 DLA CC Review activities: Air Force 99 NOTE: The activities listed above were interested in this document as of the date of this document. Since organizations and responsibilities can change, you should verify the currency of the information above using the ASSIST Online database at https:/assist.daps.dla.mil/ . Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
