1、 ENGINEERING MATERIAL SPECIFICATION Date Action Revisions Rev. 00 2013 03 19 M. Dumitrescu, FNA Controlled document at www.MATS Copyright 2013, Ford Global Technologies, Inc. Page 1 of 2 FABRIC, CALDER US PATTERN, FLAT WOVEN WRS-M1H1158-A1 38% PIR/PCR, UNLAMINATED 1. SCOPE The material defined by th
2、is specification is a woven dobby face fabric. The fabric is made with 38% PIR/PCR (Post industrial/post-consumer) recycled yarn. 2. APPLICATION This specification was released originally for material used as an interior trim fabric for 2015MY Mustang seat insert. The fabric was approved as backcoat
3、ed. 3. REQUIREMENTS 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). Materials with recycled content as defined by WRS-M99P42-A2 (Textile Materials, Identification of
4、 Recycled Content) should be used whenever technically feasible. 3.1.1 This specification must contain 38% recycled content as defined by WRS-M99P42-A2. The remaining portion of the material can come from virgin sources. 3.1.2 In addition to the requirements listed herein, the fabric shall meet all
5、requirements of WSS-M8P18-A1/A2/A3/A4 as applicable. 3.2 FABRIC CONSTRUCTION 3.2.1 Fabric Count, +/- 10% tolerance (ASTM D3775) Warp 340 ends/10 cm Weft 220 picks/10 cm 3.2.2 Fabric Weight, +/-10 % tolerance, (FLTM BN 106-01) Face fabric 326 g/m2 Backcoat 29 g/m2 Total weight 355 g/m2 3.3 COMPOSITIO
6、N (ASTM D629) Tolerance as specified in WSS-M8P18-A1/A4 Fabric 100% Polyester Backcoating EVA ENGINEERING MATERIAL SPECIFICATION WRS-M1H1158-A1 Copyright 2013, Ford Global Technologies, Inc. Page 2 of 2 3.4 YARN CONSTRUCTION (ASTM D1244) Warp 167 dtex (recycled textured polyester yarn) x 3 Weft 167
7、dtex (recycled textured polyester yarn) x 3 632 dtex (air textured PPE) x 1 or 167 dtex (textured polyester yarn) x 3 3.5 METHOD OF DYEING Piece dye/Solution dye 3.6 FINISHING OPERATIONS Wash, dye, dry, tenter, backcoated, Or as approved by Materials Engineering 4. GENERAL INFORMATION The informatio
8、n given below is provided for clarification and assistance in meeting the requirements of this specification. Contact for questions concerning Engineering Material Specifications. 4.1 Purchase departments will ensure that the material defined in this specification and shipped to any one assembly plant will be produced by one supplier only. 4.2 Global strategy to use Tri-Laminate construction in all regions. 4.3 If yarn is locally sourced it must meet the above fabric construction, composition and yarn construction. The fabric must also meet the requirements of WSS-M8P18-A1/A2/A3/A4.
