1、MIL-I-22076B AMENDMENT 1 2 April 1984 MILITARY SPECIFICATION INSULATION TUBING, ELECTRICAL, NONRIGID, VINYL, VERY LOW TEMPERATURE GRADE This amendment forms a part of Military Specification MIL-I-22076BY dated 5 August 1963, and is approved for use by all Departments and Agencies of the Department o
2、f Defense. PAGE 2 3.1: Delete and substitute: * “3.1 First article. When specified (see 6.2), a sample shall be subjected to first article inspection (see 4.2 and 6.3).“ PAGE 4 * 3.6, line 2: After “samples submitted“ delete “for qualification approval (see 4.7.13).“ and substitute “for first articl
3、e inspection (see 4.7.13).“ PAGE 5 4.1: Delete and substitute: * “4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the contractor is responsible for the performance of all inspection requirements as specified herein. Except as otherwise speci- fied in
4、the contract or purchase order, the contractor may use his own or any other facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by the Government. The Government reserves the right to perform any of the inspections set forth in the specificatio
5、n where such inspections are deemed necessary to assure supplies and services conform to prescribed requirements.“ - 4.2 (a): Delete and substitute: * “(a) First article inspection (see 4.3).“ 4.3: Delete and substitute: * “4.3 First article inspection. First article inspection shall consist of the
6、examinations and tests as specified in table IV and 4.3.1.“ Table IV: Delete title and substitute: * “TABLE IV. First article inspection.“ c THIS DOCUMENT CONTAINS -3 PAGES Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,- 1 MIL-I-22076B AMENDMENT 1 P
7、AGE 6 4.3.1: Delete and substitute: * “4.3.1 Samples for first article inspection. The sizes and quantities of tubing for first article inspection shall be as shown in table V.“ Table V: Delete title and substitute: * “TABLE V. Sizes and quantities of tubing for first article inspection.“ PAGE 15 6.
8、2: Delete and substitute: * “6.2 Ordering data. “ Add new paragraph: * “6.2.1 Acquisition requirements. Acquisition documents should specify the following: Add item (e): * “(e) First article if required (see 3.1).“ 6.3: Delete and substitute: * “6.3 First article inspection. Invitations for bids sho
9、uld provide that the Government reserves the right to waive the requirement for samples for first article inspection as to those bidders offering a product which has been previously acquired or tested by the Government, and that bidders offering such products, who wish to rely on.such production or
10、test, must furnish evidence with the bid that prior Government approval is presently appropriate for the pending contract. “ 6.4: Delete and substitute: . * “6.4 Sub-contracted material and parts. The preparation for delivery requirements of referenced documents listed in section 2 do not apply when
11、 material and parts are acquired by the contractor for incorporation into the equipment and lose their separate identity when the equipment is shipped.“ 6.5: Delete and substitute: * “6.5 Sources of stock fungus cultures. The fungi designated for use in tests may be obtained from the American Type C
12、ulture Collection, 12301 Parklawn Drive, Rockville, MD 20852.“ Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-“The margins of this amendment are marked with an asterisk to indicate where changes (additions, modifications, corrections, deletions) fro
13、m the previous amendment were made. This was done as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on the entire content irrespective of the marg
14、inal notations and relationship to the last previous amendment.“ Custodians: Army - ER Navy - SH Air Force - 85 Preparing activity: Navy - SH (Project 5970-0611) 3 t U.S. GOVERNMENT PRINTING OFFICE: 1984-705“040/A2083 *“ Provided by IHSNot for ResaleNo reproduction or networking permitted without license from IHS-,-,-
